00193802-01 - 第102页
3 Technical data User Manual SIP LACE CF 3.11 Nozzle changer for the 6-segment C ollect&Place head Sof tware version SR.101.xx 06/2003 US E dition 102 Fig. 3.1 1 - 2 Magazine and nozzle holders 3 (1) Positio ning fi …
User Manual SIPLACE CF 3 Technical data
Software version SR.101.xx 06/2003 US Edition 3.11 Nozzle changer for the 6-segment Collect&Place head
101
NOTE 3
Special magazines are available upon request (contact SIEMENSDEMATIC for details) and will
be numbered differently. 3
Picking up a nozzle
– The Collect&Place head Z axis moves down.
– The locking plate (item 2 in Fig. 3.11 - 2
) opens and releases the nozzles
– The nozzle is picked up by the sleeve of the Collect&Place head.
– The Z axis moves up.
Setting down a nozzle
– The locking plate (item 2 in Fig. 3.11 - 2) opens and releases the nozzles.
– The Collect&Place head Z axis moves down and sets the nozzle down.
– The locking plate closes.
– The Collect&Place head Z axis moves up.
Discarding defective nozzles
– The Collect&Place head Z axis moves down 14 mm towards the discarding device (item 2 in
Fig. 3.11 - 1
) and thus moves the defective nozzle into the hole in the discarding device.
– The Z axis moves up again and the nozzle is stripped from the sleeve by spring wires.
– The nozzle drops into the container (item 3 in Fig. 3.11 - 1
).
3 Technical data User Manual SIPLACE CF
3.11 Nozzle changer for the 6-segment Collect&Place head Software version SR.101.xx 06/2003 US Edition
102
Fig. 3.11 - 2 Magazine and nozzle holders
3
(1) Positioning fiducial
(2) Locking plate
(3) Nozzle holder
(4) Hole for the parallel pin for centering the magazines
(5) Hole for the parallel pin of the slide mechanism
(6) Slot for the parallel pin for centering the magazines
User Manual SIPLACE CF 3 Technical data
Software version SR.101.xx 06/2003 US Edition 3.11 Nozzle changer for the 6-segment Collect&Place head
103
3.11.4 Notes on operation
Æ When you fill a magazine with a certain nozzle type for the first time, attach an adhesive label
to identify the type.
NOTE 3
Fill the magazines off the machine and always replace complete magazines. 3
Æ Open the locking plate and place the nozzles in the nozzle holders.
Æ Close the locking plate so that the nozzles cannot drop out of the magazines.
CAUTION 3
Before you fill magazine, make sure that all the nozzles on the Collect&Place head have
been returned to their magazines. 3
Æ Programming the nozzle changer is described in the SIPLACE C Pro user manual.
NOTE 3
Æ Do not allow components to drop onto the magazines. If they do, they could jam the locking
plate.
Æ Do not allow components to drop onto free feeder locations. They will stick to the magnetic
bar. Production may have to be interrupted if the feeders are not placed on the component
table correctly. You should therefore regularly clean the magazines and free locations.