00195094-0202-MM-D3_EN - 第52页
9 4-monthly maintenance jobs SIPLACE D3 08/2008 US Edition 52 9
SIPLACE D3 9 4-monthly maintenance jobs
08/2008 US Edition
51
Z axis (front part of head) 9
a Use a brush or cottonwool bud to remove dirt from the Z axis toothed belt.
: Clean the rollers, toothed wheels and the toothed belt with a cottonwool bud or a lint-free cloth.
: Check the to
othe
d belt for wear.
Replace the toothed belt if it shows sign
s of wear (see
servicing instructions).
: Lightly grease the toothed belt with ISOFLEX TOPAS NCA 52 and remove any excess grease.
9
s Check that the Z axis guide runs easily and without play.
: Check the jaws a
nd the ball race for damage.
Contact your regional Service Center if defects are identified in the Z axis, the jaws or the b
all
race.
9
Oil the recirculating ball guide (lower bearing) 9
: Move the Z axis into its bottom pos
ition.
d Clean the grooves in the miniature roller table front
and back using cottonwool buds dipped in
ethyl alcohol.
: Wipe the n
eedle of the oil dispenser clean.
Do not force oil out of the oil dispenser. A visible drop would be too much oil. 9
9
9
f Simply place the needle immediately beside the ball cage/bearing on the grooves of the guide
rail. The action will cause sufficient oil to reach the grooves (capillary effect).
: Move the Z axis up and down several ti
mes to distribute the film of oil.
9
9 4-monthly maintenance jobs SIPLACE D3
08/2008 US Edition
52
9
SIPLACE D3 9 4-monthly maintenance jobs
08/2008 US Edition
53
Star 9
a Wipe the star using a lint-free cloth.
: Apply a light film of ISOFLEX TOPAS NCA 52 grease to the running surface of the star brake.
Remo
ve
any visible excess grease.
9
Make sure that no dirt or grease gets into the vacuum channels. 9
9
9
9
The vacuum distributor disk is glued on. 9
9
9
9
Segments 9
9
When cleaning, be careful not to damage the sleeve retaining springs in the segments. 9
Do not push the cottonwool bud into the segment as far as
the retaining spring; otherwise the re-
taining spring may be pulled out. 9
9
s Carefully clean the segments using a cottonwool bud moistened with ethyl alcohol.
d Remove any visible dirt around the segments.
9
9
Valve casing 9
: Remove the valve plungers.
f Clean the valve casing using a cottonwool bud moistened with ethyl alcohol.
: Then clean all around the valve casings.