00196851-02 OG SIPLACE Operation of X and SX-Series with SSC (SW70x) - 第128页

Refilling Component Reels - Splic ing - Required Tools and Mater ials : 128 Splicing - Required Tools an d Materi als These tools and ma terials ar e re quired for tape splicing. 1. Adhesive t ape (small) 2. Tweez ers 3.…

Refilling Component Reels - Refill a track :

127

Refilling Component Reels

Continuously check the component reels to see if they

are running out – if there is around 1m of tape remaining

then it is time to splice a new reel!

Obtain the new reel of components from the storage

location.

1. Scan the control barcode Refill of the location to be

verified.

2. Scan the Track barcode of the packaging unit be

refilled.

3. Scan all configured barcodes of the packaging unit.

NOTICE! Depending on the configuration of

Setup Center further steps can be necessary during refill.

Therefore always watch the display of the barcode

reader.

e.g. scanning of user or reordering a packaging unit.

Refilling Component Reels - Splicing - Required Tools and Materials :

128

Splicing - Required Tools and Materials

These tools and materials are required for tape splicing.

1. Adhesive tape (small)

2. Tweezers

3. Scissors

4. Splicing rivets

5. Splicing tool

6. Adhesive tape (large)

Refilling Component Reels - Preparation of carrier tape end :

129

Preparati on of carrier tape end

Carrier tape end:

1. Carrier tape end is protruding from the feeder

2. Cut carrier tape exactly between two pockets in the

middle of the hole, as shown in picture. All pockets

must be full to end of carrier tape

Note: Carrier tape splicing must occur with enough lead

tape length to prevent the machine to be stopped.