00196851-02 OG SIPLACE Operation of X and SX-Series with SSC (SW70x) - 第131页

Refilling Component Reels - Splicing the carrier tape : 131 Splicing the carrier tape 1. Place the rivet on t he holding pins, prongs facing up! Note: Holding p ins! 2. Place the end of the carrier tape over half of the …

Refilling Component Reels - Preparation of new carrier tape :

130

Preparation of new carrier tape

New carrier tape:

1. Peel cover tape back approximately the width of one

component pocket

2. Cut carrier tape exactly between two pockets in the

middle of the hole, as shown in picture. All pockets

must be full to end of carrier tape beginning

Note: Be careful not to cut the cover tape to allow cover

tape overlap onto old cover tape!

Refilling Component Reels - Splicing the carrier tape :

131

Splicing the carrier tape

1. Place the rivet on the holding pins, prongs facing up!

Note: Holding pins!

2. Place the end of the carrier tape over half of the rivet

and close the lock

3. Place beginning of the carrier tape over the other half

of the rivet and lock it in place. The cover tape must

lay on top of the end of the old carrier tape Note:

Overlaying film

4. Crimp the splicing tool to the first set point

Refilling Component Reels - Splicing the carrier tape :

132

Splicing the carrier tape

5. Remove half of the adhesive protector. Do not touch

the sticky surface!

6. Lay the adhesive strip on top of the carrier tape and

press firmly

7. Remove carefully the second half of the protector strip

and press firmly on the adhesive strip

8. To splice the tape, squeeze the splicing tool until it

releases