182050 User manual - 第28页
semi automatic 0$&+,1( 352*5$ 00,1* 67$*($ 0 $*1( 7,&3,//$56 722/,1* 1.18 User Manual Software Ve rsion 07SP02 27. Select Cont act Heig ht (F3). The following windo w and menu bar is displ ayed: 28. Selec…
semi automatic
0$&+,1(352*5$00,1*
67$*($0$*1(7,&3,//$56722/,1*
Software Version 07SP02 User Manual 1.17
14. Select Auto Board (F1).
15. Select Open Cover (F7).
16. Raise the printhead cover.
17. Position the outermost magnetic support pins on the rising table under the
board.
18. Select Board Clamps (F3) to open the clamps.
19. Remove the board from the rails and select Board Clamps (F3) to close the
clamps.
20. Complete the positioning of the magnetic support pins.
21. Select Board Clamps (F3) to open the clamps.
22. Place the board back on the rails over the tooling and select Board Clamps
(F3) to close the clamps.
23. Select Exit (F8).
24. Lower the printhead cover.
25. Press the System button.
26. Select Vision Height (F3). The message ‘Table at Vision Height. Check
Tooling Clearance’ is displayed.
Auto
Board
Manual
Board
Exit
Unload
Vision
Height
Home
Height
Board
Clamps
Change
Screen
Open
Cover
Exit
Board
Clamps
Exit
Board
Clamps
Exit
Board
Clamps
Exit
Board
Clamps
Exit
Board
Clamps
Exit
Unload
Vision
Height
Home
Height
Board
Clamps
Change
Screen
Open
Cover
Exit
semi automatic
0$&+,1(352*5$00,1*
67$*($0$*1(7,&3,//$56722/,1*
1.18 User Manual Software Version 07SP02
27. Select Contact Height (F3).
The following window and menu bar is displayed:
28. Select Continue (F1). The message ‘Table at Contact Height. Check
Tooling Clearance’ is displayed.
29. Select Open Cover (F7).
30. Raise the printhead cover.
31. Check that the setup of the tooling is adequate for the board, adjust as
necessary.
NOTE
If adjustment is required, this can be carried out at Transport Height.
Contact
Height
Transprt
Height
Change
Screen
Open
Cover
Exit
Contact Height Warning
WARNING Check for obstructions between
the Rails and the Screen
Continue
Open
Cover
Exit
Continue
Open
Cover
Exit
Vision
Height
Open
Cover
Exit
semi automatic
0$&+,1(352*5$00,1*
67$*($0$*1(7,&3,//$56722/,1*
Software Version 07SP02 User Manual 1.19
32. Lower the printhead cover.
33. Press the System button.
34. Select Exit (F8).
35. Select Exit (F8).
The following window and menu bar is displayed:
36. Select Continue (F1).
37. Select Auto Board (F1). The message ‘Board on rails, remove and
continue’ is displayed.
38. Remove the board from the rails.
39. Select Continue (F1).
40. Go to Stage 7.
Exit
Vision
Height
Open
Cover
Exit
Leaving Generic Tooling
WARNING You are about to return
to the Setup Page
Clear all tooling setup
equipment before proceeding
Continue Exit
Continue Exit
Auto
Board
Manual
Board
Continue
Open
Cover