182050 User manual - 第79页
semi automatic 0$&+,1 (352*5 $00,1 * 67$*( ',6(7 83 Software Version 07SP02 User Manual 1.69 ST AGE 10 - 2DI SETUP For a complete e xplanation of 2D Ins pection and it s setup ref er to the 2D Inspecti …
semi automatic
0$&+,1(352*5$00,1*
67$*(35,17,167(302'(
1.68 User Manual Software Version 07SP02
11. Select Edit Data (F3).
12. Enter the X Offset, Y Offset and θ Offset, calculated in Step 10 to both the
Forward and Reverse set of offsets.
13. Repeat Steps 1-10 until the alignment is correct for both a forward and
reverse print.
14. If 2D Inspection is being used continue with Stage 8, if 2D Inspection isn’t
being used go to Stage 9.
Auto
Adjust
Load
Data
Edit
Data
Setup
Squeegee
Change
Screen
Change
Tooling
Change
Language
Exit
semi automatic
0$&+,1(352*5$00,1*
67$*(',6(783
Software Version 07SP02 User Manual 1.69
STAGE 10 - 2DI SETUP
For a complete explanation of 2D Inspection and its setup refer to the 2D
Inspection chapter of this manual.
semi automatic
0$&+,1(352*5$00,1*
67$*(35,17,158102'(
1.70 User Manual Software Version 07SP02
STAGE 11 - PRINT IN RUN MODE
1. Select Setup (F6).
2. Select Mode (F1) until Auto is indicated in the mode option on the monitor.
3. Select Exit (F8).
4. Place the board onto the rails.
5. Select Run (F1). If squeegees are being used continue with Step 6, if
ProFlow is being used go to Step 21.
6. During the first print stroke, when the squeegee is down printing on the
board, select Stop Cycle (F2). The print cycle stops and the printer lid bolt
releases allowing access to the print carriage.
7. Raise the printhead cover.
8. Release the screws holding one paste deflector allowing it to drop into
contact with the stencil.
9. Insert a 0.25mm feeler between the deflector and the stencil. Tighten the
screws checking that the 0.25mm gap remains.
Run
Open
Cover
Paste
Load
Clean
Screen
Setup Monitor Maint.
Mode
Load
Data
Edit
Data
Setup
Squeegee
Change
Screen
Change
Tooling
Change
Language
Exit
Mode
Load
Data
Edit
Data
Setup
Squeegee
Change
Screen
Change
Tooling
Change
Language
Exit
Run
Open
Cover
Paste
Load
Clean
Screen
Setup Monitor Maint.
End
Run
Stop
Cycle