00197498-03_UM_SiplaceCA-Serie_EN - 第327页
User Manual SIPLACE CA-Series 5 Setting up and Commissioning From software version SC.708.0 Edition 12/20 14 EN -DRAFT 5.5 Setting Up the Placement Machine 327 5 Fig. 5.5 - 27 Setting the height for the outer machine fee…
5 Setting up and Commissioning User Manual SIPLACE CA-Series
5.5 Setting Up the Placement Machine From software version SC.708.0 Edition 12/2014 EN -DRAFT
326
5.5.17 Final Adjustment of Placement Machine
Place the machine spirit level in the X and then the Y direction on the sides of the conveyor
in placement area 1 (see fig. 5.5 - 26
). The board conveyor width has been preset:
Single conveyor 210 mm
Dual conveyor, lane 1 100 mm
Dual conveyor, lane 2 210 mm 5
5
Measure the distance between the upper edge of the PCB conveyor belt and the underside.
This distance should be 800 mm, 900 mm, 930 mm or 950 mm.
5
Fig. 5.5 - 26 Adjusting the placement machine in the X and Y directions
Use the fork wrench SW36 to adjust the setting screw M24x2x120 (item 1 in fig. 5.5 - 27), so
that the fluid in the machine spirit level does not deviate from its zero point at the required
conveyor height.
PLEASE NOTE
When using a dual conveyor, the spirit level for adjustment needs to be always placed
on the outer sides of the placement machine, when measuring in the X direction.
User Manual SIPLACE CA-Series 5 Setting up and Commissioning
From software version SC.708.0 Edition 12/2014 EN -DRAFT 5.5 Setting Up the Placement Machine
327
5
Fig. 5.5 - 27 Setting the height for the outer machine feet
(1) Setting screw M24x2x120 for height adjustment
(2) Outer machine foot
(3) Clamping piece
(4) Hexagon socket-head screw M24x90
Check the required board conveyor height.
Once the placement machine has been correctly aligned, use the torque wrench to tighten
the hexagon socket-head screws M24x90 (item 4) to clamp the clamping pieces on all outer
machine feet (item 3).
5
PLEASE NOTE
Vibration at low tightening torques
The tightening torque is 130 Nm. If you use a lower tightening torque, the placement ma-
chine may tend to vibrate.
Use a sufficiently high tightening torque.
5 Setting up and Commissioning User Manual SIPLACE CA-Series
5.5 Setting Up the Placement Machine From software version SC.708.0 Edition 12/2014 EN -DRAFT
328
Use the hook wrench to unscrew the middle machine feet roughly 135 - 145, until these are
positioned firmly on the ground.
Make sure that the middle machine feet are not unscrewed too far, otherwise they may mis-
align the placement machine.
5
Fig. 5.5 - 28 Aligning and locking the middle machine feet
Recheck the exact alignment of the placement machine with the machine spirit level.
Use the fork wrench SW65 to tighten the lock nut M24 (item 3).
5.5.18 Removing the Shipping Braces
– Remove all the shipping braces from the gantry axes.
(1) Spacer
(2) Middle machine foot
(3) Lock nut M24