00197498-03_UM_SiplaceCA-Serie_EN - 第357页
User Manual SIPLACE CA-Series 6 Working with the Machine From software version SC.708.0 Edition 12/20 14 EN -DRAFT 6.4 SWS Tasks 357 6.4.4 Inserting the Magazine into the Magazine Lift Open the sliding door of the maga…
6 Working with the Machine User Manual SIPLACE CA-Series
6.4 SWS Tasks From software version SC.708.0 Edition 12/2014 EN -DRAFT
356
6.4 SWS Tasks
6.4.1 Switching on the SIPLACE CA
First switch on all SWSs of the SIPLACE CA.
The modules are starting up. As long as the placement machine is not yet switched on, an error
message will be displayed on the screen of the SWS module, which points out that the safety cir-
cuit is not closed.
Switch the placement machine on.
Station computer and machine controller are starting up.
As soon as the placement machine has been started up and the start button has been pressed,
the error message regarding the not-closed safety circuit vanishes from the SWS monitors. Initial-
ize the SWS module.
When the initializing process is completed, the SWSs are ready to operate and in standby.
6.4.2 Switching off the SIPLACE CA
Switching off the SWS
Complete all processes running at the SWS modules.
In the SWS computer GUI switch over to the Production -> Other view and click on the red
switch-off button there.
SWS GUI and Linux are shut down properly. 6
Switch off the SWS at the main switch.
Repeat this, if necessary, for each other SWS module.
Switching off the Placement Machine
Close all current processes in the placement machine.
Shut down the station computer.
Switch the placement machine off at the main power switch.
6.4.3 Filling the Magazine
Refill the magazine with the wafer frames.The centering notches of the wafers frames must
point to the opening of the magazine.
6
PLEASE NOTE
When using frame adapters for 5, 6 or 7 inch wafers, make sure that you only use
every second slot.
User Manual SIPLACE CA-Series 6 Working with the Machine
From software version SC.708.0 Edition 12/2014 EN -DRAFT 6.4 SWS Tasks
357
6.4.4 Inserting the Magazine into the Magazine Lift
Open the sliding door of the magazine lift and place the magazine onto the plate. The center-
ing notches of the wafers must face the machine. Make sure that the magazine latches prop-
erly.
Fig. 6.4 - 1 Inserting the magazine
6
PLEASE NOTE
When inserting the wafer frame, the recesses in the wafer frame must point in the feed-
in direction.
6 Working with the Machine User Manual SIPLACE CA-Series
6.4 SWS Tasks From software version SC.708.0 Edition 12/2014 EN -DRAFT
358
6.4.5 Setting up the Needle Configuration for the Ejection System
In the SWS GUI, switch over to the Manual operations -> Wafer handling view and click on
the Go to change position button.
The wafer table is removed.
In the SWS GUI, switch over to the Manual operations -> Die handling view and select the
Ejection unit tab.
Click on the button.
The wafer table is removed, the die ejector is moved upwards can be accessed.
6
Switch off the placement machine and the SWS properly.
6
Open the protective cover above the SWS.
Open the bayonet lock at the centering unit and take the needle kit out.
CAUTION
Risk of damage!
When moving the wafter table manually, the ejection system which was moved upwards
could collide with the wafer table and be damaged.
Do not push the wafer table manually.