00192328-01 - 第74页

2 Retrofitt. Instruct. RV6-DLM1 Head & Nozzle Chang. RV6 Standard (Optionen) S IPLACE S-25 HM 2.5 SITEST: Adjust Configuration, Entry Zero Point Compens. Values RV6 Head 02/01 Issue 72  &RQI LJXUDWLRQ  1R]…

SIPLACE S-25 HM 2 Retrofitt. Instruct. RV6-DLM1 Head & Nozzle Chang. RV6 Standard (Optionen)

02/01 Issue 2.5 SITEST: Adjust Configuration, Entry Zero Point Compens. Values RV6 Head

 &RQILJXUDWLRQ59'/0+HDG

In the SITEST main view select -> "Settings" ->The menu "Machine Configuration" will appear: 

Å Select the relevant "Gantry 1/2" (registration card) -> Click on the DLM1 head (6-nozzle head)

mounted on the gantry -> Select "Accept".

2 Retrofitt. Instruct. RV6-DLM1 Head & Nozzle Chang. RV6 Standard (Optionen) SIPLACE S-25 HM

2.5 SITEST: Adjust Configuration, Entry Zero Point Compens. Values RV6 Head 02/01 Issue

 &RQILJXUDWLRQ1R]]OH&KDQJHU596WDQGDUG

Å Change to the SITEST program.

Å The main view will appear.

Å Starting from the main view, select -> Settings -> Machine configuration -> "Gantry 1" or "Gan-

try 2", depending on which location the nozzle changer RV6 was installed at.

The following screen will appear:



Å Click on "Nozzle changer" -> "Edit.." (button).

The following screen will appear:

SIPLACE S-25 HM 2 Retrofitt. Instruct. RV6-DLM1 Head & Nozzle Chang. RV6 Standard (Optionen)

02/01 Issue 2.5 SITEST: Adjust Configuration, Entry Zero Point Compens. Values RV6 Head

Å Click on "RV6 Standard" (long nozzle changer for the RV6 head) -> Select "Accept" (button).

Take note of:

If a RV6-DLM1 head AND an MTC was retrofitted, select the nozzle changer "RV6 MTC" ->

"Accept" (button) -> again "Accept".

After the overall reference run, the nozzle changer MTC is configured and measured in accor-

dance with the Retrofitting Instructions for MTC, Item no. see: Section 2.3.6.

Å Calibrate the nozzle changer after the dynamics adjustment and the calibration of the heads,

i.e., after taking the steps below (see: Section 2.8).

 &RQFOXGLQJ$FFHSWDQFHRIWKH&RQILJXUDWLRQ

Å After completely adjusting the machine configuration:

Exit the menu "Machine Configuration" by pressing "Accept" (button).

The main view will be displayed and the messsage will appear:

7KHPDFKLQHFRQILJXUDWLRQKDVFKDQJHG

6KXWGRZQ!5HVWDUWPDFKLQH!&OLFNRQ2.EXWWRQ

Å Boot up the machine and change back to the SITEST program.