00191494-01 - 第58页
Error Messages Short Reference SIPLACE 80 S-15/F3/G 03/99 Issue Software Version SR.010.x x 56 513 Unknown operating state mes sage CAUSE ● Software error REMEDY ● Reboot 514 Illegal operating state CAUSE ● Software erro…
Short Reference SIPLACE 80 S-15/F3/G Error Messages
03/99 Issue Software Version SR.010.xx
55
506 Error during RMOS System Call DALOC
CAUSE
● Software error
REMEDY
● Reboot and inform Siemens Service.
507 Error during RMOS System Call ALOC
CAUSE
● Software error
REMEDY
● Reboot and inform Siemens Service.
508 Error during RMOS System Call LOOK
CAUSE
● Software error
REMEDY
● Reboot and inform Siemens Service.
509 Error during RMOS System Call RIO
CAUSE
● Software error
REMEDY
● Reboot and inform Siemens Service.
510 Error during RMOS System Call CREATEDRIV
CAUSE
● Software error
REMEDY
● Reboot and inform Siemens Service.
511 Error during RMOS System Call MALLOC
CAUSE
● Software error
REMEDY
● Reboot and inform Siemens Service.
512 Incorrect value of state counter
CAUSE
● Software error
REMEDY
● Reboot
Error Messages Short Reference SIPLACE 80 S-15/F3/G
03/99 Issue Software Version SR.010.xx
56
513 Unknown operating state message
CAUSE
● Software error
REMEDY
● Reboot
514 Illegal operating state
CAUSE
● Software error
REMEDY
● Reboot
515 SV: Unknown data code
CAUSE
● Software error
REMEDY
● Inform Siemens Service
516 SV: Incorrect data length
CAUSE
● Software error
REMEDY
● Inform Siemens Service
517 Software error: Answer from coplanarity too long
CAUSE
● Software error: the answer from coplanarity exceeds the buffer length in the MC
REMEDY
● Repeat the coplanarity measurement; notify Siemens Service.
518 SV: Unknown message code from other MC
CAUSE
● Software error
REMEDY
● Inform Siemens Service.
519 SV: Unknown message code from station computer
CAUSE
● Software error
REMEDY
● Inform Siemens Service.
Short Reference SIPLACE 80 S-15/F3/G Error Messages
03/99 Issue Software Version SR.010.xx
57
520 Unknown data code in MC1 during data exchange
CAUSE
● Software error
REMEDY
● If there are problems after this, reset station, inform Siemens Service.
521 Software error in SGL Functions
CAUSE
● Incorrect message to single function (Info1) operator error during transition to single function or
fatal error handling ( start button not pressed ).
REMEDY
● Possibly rebooting
522 Syntax error in command to component table
CAUSE
● Software error; interface cable reversed.
REMEDY
● Reboot; connect interface cable correctly.
523 Command not executed, component table not referred
CAUSE
● Power failure while component carriage moving.
REMEDY
● Check power supply and inform Siemens Service.
524 Command not executed, component table in refill position
CAUSE
● Software error
REMEDY
● Reboot
525 WPC: No tray available.
CAUSE
● Software error
REMEDY
● Reboot
526 WPC: Sent set-up contains errors.
CAUSE
● Software error
REMEDY
● Reboot