80S-20贴片机 - 第103页
SIPLACE 80S-20/F4 Service Manual 4 Power Supply Edition 01/96 4.3 Control Unit 4 - 17 Fig. 4.3.2 T op view of the power supply unit in the control unit
4 Power Supply SIPLACE 80S-20/F4 Service Manual
4.3 Control Unit Edition 01/96
4 - 16
Fig. 4.3.1 Control unit - partial view of the front with power supply unit
To make measurements at the back of the control unit proceed as follows:
● Switch the placement machine off and disconnect it from the power supply.
● Undo the retaining screw of the control unit and pull out the control unit.
CAUTION
Q
Make sure you do not damage the cable or put tensile stress on the snap-in connections.
● If necessary, support the control unit on a stool.
● Reconnect the machine to the power supply. Switch it on and then carry out the measurements required
(see Fig. 4.3.2). You should comply with the safety instructions in Section 1.
SIPLACE 80S-20/F4 Service Manual 4 Power Supply
Edition 01/96 4.3 Control Unit
4 - 17
Fig. 4.3.2 Top view of the power supply unit in the control unit
4 Power Supply SIPLACE 80S-20/F4 Service Manual
4.3 Control Unit Edition 01/96
4 - 18