80S-20贴片机 - 第114页

5 Gantries SIPLACE 80S-20/F4/F4-6/F5 Service Manual 5.1 Introduction Edition 09/99 5 - 6 5.1.4 Preparatory W ork We recomme nd that yo u alway s remove the com ponent s table be fore wor king on th e gantry (see Se ction…

100%1 / 483
SIPLACE 80S-20/F4/F4-6/F5 Service Manual 5 Gantries
Edition 09/99 5.1 Introduction
5 - 5
Fig. 5.1.1 General view of gantry from above: 80S-20 placement system
5 Gantries SIPLACE 80S-20/F4/F4-6/F5 Service Manual
5.1 Introduction Edition 09/99
5 - 6
5.1.4 Preparatory Work
We recommend that you always remove the components table before working on the gantry (see Section
12.1). This will make your servicing work much easier to perform.
5.1.4.1 Removing and Installing the Changeover Table
● Disconnect the changeover table’s electrical and pneumatic connections.
● Open the locking lever.
● With a lift truck lift the components table over the taper pins and move the changeover table out of the
machine.
● To re-install the changeover table proceed in the reverse sequence of operations.
Key to Fig. 5.1.1
.
Key to Fig. 5.1.2
.
1 Y axis, gantry 2 2 Y-axis drive motor, gantry 2
3 X axis, gantry 1 4 X-axis drive motor, gantry 1
5 Y axis, gantry 1 6 Y-axis drive motor, gantry 1
7 X axis, gantry 2 8 X-axis drive motor, gantry 2
9 Used tape cutters 10 Components tables
11 Cover for conversion board 12
1 X axis 2 Cover for conversion board, large axis
3 X-axis drive motor 4 Y axis
5 Y-axis drive motor 6 Stop
7 Components tables 8 Used tape cutter
9 IC vision system 10 FC vision system
SIPLACE 80S-20/F4/F4-6/F5 Service Manual 5 Gantries
Edition 09/99 5.1 Introduction
5 - 7
Fig. 5.1.2 General view of gantry from above: 80F
4
/F
4
-6/F
5
placement system