80S-20贴片机 - 第363页
SIPLACE 80S -20/F4/F5 S ervice Man ual 12 Vision systems Edition 09/99 12.3 Replacing the flip-chip vision camera and illumination controller (SIPLACE 80F) 12 - 11 5HSODFLQJWK HIOLS FKLSYLVLRQFDPHUDDQG LOOXPL…
SIPLACE 80S-20/F4/F5 Service Manual 12 Vision systems
Edition 09/99 12.3 Replacing the flip-chip vision camera and illumination controller (SIPLACE 80F)
12 - 11
5HSODFLQJWKHIOLSFKLSYLVLRQFDPHUDDQG
LOOXPLQDWLRQ FRQWUROOHU 6,3/$&()
NOTE
Make sure that you always replace the flip-chip vision camera and the illumination control board Y1019 as a
pair since the two components are adjusted to each other. If you fail to do so, you will have problems with flip-
chip centering.
7RROVLQVSHFWLRQPHDVXULQJDQGWHVWHTXLSPHQWUHTXLUHG
6SDUHSDUWV
5HPRYLQJWKHIOLSFKLSYLVLRQFDPHUD
● Remove the component changeover table (see Section 12.1, page 12 - 5).
● Remove the cover of the flip-chip camera (see A in Fig. 12.3.1).
● Disconnect camera cable F0627-W2 from plug X47 of the CCD camera (see B in Fig. 12.3.1).
● Disconnect cable F0616-W2 from plug X1bz of the conversion board ’Y0044 bottom part’ (see B in Fig.
12.3.1).
● Undo the two M8 x 50 hexagon socket screws and remove the flip-chip camera (see C in Fig. 12.3.1).
Set of hexagon socket screwdrivers
SITEST program
)URPLWHPQXPEHU
Flip-chip sensor SIPLACE 80F
4
00116417-01
Current regulator for IC illumination
(board Y1019 included in the camera package)
00323147-02
