HS50_advance_level 1_20200522_221201 (1) - 第24页
06/2002 E dition Studen t Guide H S-50 Advance d I 1 Safety Co nsideration 8 1.1. 1 Safety in struct ions fo r clos ing th e protect ive covers T o prevent all risk of injury when closi ng the protective covers on t he m…
Student Guide HS-50 Advanced I 06/2002 Edition
1 Safety Consideration
7
RISK OF COMBUSTION 1
: Never carry out cleaning work using alcohol near a exposed light or flame.
: Never spray lubricant or cleaning agent from aerosol cans near a exposed light or flame.
: DO NOT SMOKE.
1
WARNING 1
: Never carry out cleaning work using alcohol near a exposed light or flame.
: DO NOT SMOKE.
: Always wear safety goggles and gloves when cleaning modules with concentrated ethyl alco-
hol.
: If you accidentally spray ethyl alcohol in your eyes, wash your eyes immediately with lots of
water.
1
06/2002 Edition Student Guide HS-50 Advanced I
1 Safety Consideration
8
1.1.1 Safety instructions for closing the protective covers
To prevent all risk of injury when closing the protective covers on the machine, all personnel must
be required to follow the instructions below when closing the covers. 1
RISK OF INJURY HANDS IF THE PROTECTIVE COVERS ARE NOT CLOSED
CORRECTLY 1
1
Fig. 1.1 - 1 Safety instructions for closing the protective covers
(1)Protective covers
(2)Recessed grips
1
➠ When opening or closing the protective covers, always hold the covers by the recessed grips.
If the shock absorbing capacity of the protective covers reduces over time, for example, your
hands can easily be crushed if you do not close the covers using the recessed grips.
1
Student Guide HS-50 Advanced I 06/2002 Edition
1 Safety Consideration
9
1.1.2 Safety instructions for changing the component table
WARNING Never reach into the gaps between the component changeover table and
the placement system frame while the machine is running (item 1 in Fig. 1.1 - 2). 1
WARNING Always check that the component table is docked on the placement sys-
tem before connecting or disconnecting the power cable for the component changeover table at
the socket on the placement system (item 2 in Fig. 1.1 - 2). 1
WARNING NEVER connect the connecting cable for the component table to the
socket on the placement system and then operate the component table outside the machine via
the compressed air control unit (item 3 in Fig. 1.1 - 2). 1
1
Fig. 1.1 - 2 Safety instructions for the component table