HS50_advance_level 1_20200522_221201 (1) - 第502页

S tud ent Guid e HS-50 A dvanced I 0 6/2002 E dition 12 Pr eventive Maintenance 69 : The Y axis gantry mus t have a g rease nipple to be able to grease it using the grease gun. If t his is not the cas e, remove the s cre…

100%1 / 567
06/2002 Edition Student Guide HS-50 Advanced I
12 Preventive Maintenance
68
Student Guide HS-50 Advanced I 06/2002 Edition
12 Preventive Maintenance
69
: The Y axis gantry must have a grease nipple to be able to grease it using the grease gun.
If this is not the case, remove the screw (figure B) and insert a grease nipple (part no.:
00366104-01, 8-pack).
a Place the grease gun (part no.: 00366174-01), filled with ISOFLEX TOPAS NCA 52, straight
onto the grease nipple.
: Give one squeeze of the grease gun.
12
If the grease comes out beside the grease nipple, the bearing can be full or the grease nipple
doesn’t shut tightly. In this case use a new grease nipple.
: Grease the other gantry carriage in the same way.
12
Remember to grease both visible grease nipples on each gantry (this will mean greasing eight
grease nipples in total on the HS machine).
: Move the gantry around 30 cm to distribute the grease.
: Apply grease and distribute three more times. This ensures that the correct amount of grease
is applied.
: Use a cloth to remove any excess grease on and around the grease nipple.
: Repeat the greasing process on all four gantries.
06/2002 Edition Student Guide HS-50 Advanced I
12 Preventive Maintenance
70