3OM-1751-002w_G5S.pdf - 第176页
3OM-1751 2-8 1303-001 2.1.4 "Conv Wid" T ab Sheet [1] F3B7 [1] W1 [mm] W2 [mm] This offset data is used to adjust the conveyor width to the absolute values. Enter the difference between the actually measured va…
3OM-1751
2-71303-001
2.1.3 "Pos Level" Tab Sheet
[1]
F3B6
[1] BL [mm]
BR [mm]
These parameters are used to absorb the deviation in the PCB positioning
level for the Support pin up/down operation.
Graphic
Development
2.1 "Device Offset" Window
3OM-1751
2-81303-001
2.1.4 "Conv Wid" Tab Sheet
[1]
F3B7
[1] W1 [mm]
W2 [mm]
This offset data is used to adjust the conveyor width to the absolute values. Enter
the difference between the actually measured value from the xed chute to the
movable chute and the half of the specied width, when the conveyor width is set
up to the specied one.
W1 Offset
: In the case that the actually measured value is larger than half of the
specied one, a positive (+) value must be entered.
W2 Offset
: In the case that the actually measured value is smaller than half of
the specied one, a negative (-) value must be entered.
A
NL-W1
NR-W1
NB-W1
NL-W2
NR-W2
NB-W2
(+)
(-)
Front Side of Machine
Movable Chute
Fixed Chute
F3B8
Graphic
Development
2.1 "Device Offset" Window
3OM-1751
2-91303-001
2.1.5 "Mark Offset" Tab Sheet
F3B9
"Mark (Center)" represents the standard mark position captured by the PEC
recognition camera when the rotational center of the head is moved to the area
above the component recognition camera.
"Mark (Right)" and "Mark (Left)" are the standard mark positions captured by the
PEC recognition camera when the pertinent nozzle is moved to the center of the
component recognition camera with the head being rotated 90° or 270°.
Graphic
Development
2.1 "Device Offset" Window