OM-1241-005_w - 第74页
2-1 1 AIX-ML T-ID 2.3.2 Operation Mode The corresponding window makes it possible to set the reduction rate of the running speeds for the tray elevator and traverse. Fig. B5-3 "Opn. Mode" Window (2/4) When the …
2-10
AIX-MLT-ID
2.3.1 Alternate Mode
The corresponding window makes it possible to set parameters for the
magazine alternate mode.
[1]
[2]
[3]
[4]
Fig. B5-2 "Altn Mode" Window (Multi-Layer Tray Feeder #3 Used)
[1] Selection Buttons
[Altn Fdr] Button :
When pressed, this button opens the "Altn
Fdr" window.
[Altn Tray Mag] Button
:
When pressed, this button opens the "Altn
Tray Mag" window.
[2] Altn Tray Mag Mode
[Enable] Button :
When selected, this button validates the
magazine alternate mode.
[Disable] Button :
When selected, this button invalidates the
magazine alternate mode.
[3] Order of Priority
[Mag #1] Button :
When this button is pressed, the
components in Magazine #1 are used prior
to the others.
[Mag #2] Button :
When this button is pressed, the
components in Magazine #2 are used prior
to the others.
[4] [Set] Button
When pressed, this button reects the items selected in [2] and [3] on
the machine.
0804-004
2.3 Operation
2-11
AIX-MLT-ID
2.3.2 Operation Mode
The corresponding window makes it possible to set the reduction rate of the
running speeds for the tray elevator and traverse.
Fig. B5-3 "Opn. Mode" Window (2/4)
When the multi-layer tray feeder is connected, the following items are added.
[Tray Elevator] Button :
This button can be used to set the rate of the
elevator speed reduction.
[Tray T
raverse] Button :
This button can be used to set the rate of the
traverse speed reduction.
0804-004
2.3 Operation
2-12
AIX-MLT-ID
2.3.3 Test Mode
The corresponding window makes it possible to set parameters for the test
mode.
Fig. B5-4 "Test Mode" Window
Test Patterns
Set the contents of the test mode.
The following shows the items related to the multi-layer tray feeder.
Tray Matrix Update Dsbl.
Tray Pll Det Dsbl.
Tray Comp Feed Dsbl.
Notice
Wrong selections (test run in wrong modes) will cause various
deciencies such as component picks by vacuum nozzles,
scattering of components, or collision with the chute, etc.
0804-004
2.3 Operation