OM-1241-005_w - 第86页

2-22 AIX-ML T-ID 3.3.1 T ray Unit This window enables the operator to manually operate the multi-layer tray feeder . [1] [2] [3] [4] [5] Fig. B16 "TRA Y UNIT" Window [1] Sel T ray The installed multi-layer tray…

100%1 / 211
2-21
AIX-MLT-ID
3.3 Unit Adjustment
When the [UNIT ADJ] button on the submenu bar of the "MAINT" window
is pressed, the "UNIT ADJ. >> LINEAR Measure" window appears as an
initial one.
Fig. B15 "LINEAR Measure" Window
0804-004
3.3 Unit Adjustment
2-22
AIX-MLT-ID
3.3.1 Tray Unit
This window enables the operator to manually operate the multi-layer tray
feeder.
[1] [2] [3]
[4] [5]
Fig. B16 "TRAY UNIT" Window
[1] Sel Tray
The installed multi-layer tray feeders are displayed, making it possible
for the operator to select one of the feeders.
[2] Set Data
Speed deceleration rates can be specied for each section of the multi-
layer tray feeder.
Elevator #2 Dclr :
This is used to set the speed reduction rate of
Elevator #2.
Elevator #2 Dclr
:
This is used to set the speed reduction rate of
Elevator #1.
Traverse Dclr :
This is used to set the speed reduction rate of the
Traverse.
Cmp Hgt Sensor :
Thi
s is used to set the level in which the height of
the Cmp Hgt Sensor.
0804-004
3.3 Unit Adjustment
2-23
AIX-MLT-ID
[3] "Information" Group Box
Displayed is the data of the multi-layer tray feeder that was used for the
previous adjustment.
The following items are displayed.
Elev No.
Draw Step No.
Cmp Hgt
Mag Type
Time
Note
The data being edited will not be displayed as information.
[4] Operational Object Selection Buttons
Select the object for the operation.
When pressed, this button moves the specied step to the traverse
drawout position.
[5] Operation Selection Buttons
[Pallet Chng Pos] Button :
Whe
n pressed, this button moves the
elevator to the component supply
position.
[Mag Chng Pos] Button :
When pressed, this button moves
the elevator to the magazine change
position.
[Pallet Draw Position] Button :
When pressed, this button moves
the elevator to the traverse drawout
position.
[Up (Step)] Button :
When
pressed, this button moves the
elevator upward by 1 pitch of the
pallet.
[Down (Step)] Button :
When pressed, this button moves the
elevator downward by 1 pitch of the
pallet.
[Pallet Draw] Button :
When pressed, this button activates
the traverse to draw out the pallet.
[Pallet Storage] Button :
When pressed, this button stores the
pallet drawn out on the traverse.
0705-003
3.3 Unit Adjustment