4OM-1064-001 - 第11页
Section 1 Periodic Inspections 9910-001 1-1 Tg0249-PM-MM
WARNING
Precautionary Measures in Maintenance and Inspection Work
0004-002 8 Tg0249-PM-MM
Before performing maintenance work, turn off the
power switch and the air source of the machine
and lock the power breaker using the padlock.
• Designate a personnel who can have charge of the
padlock key.
•
If the provided padlock is lost or damaged, purchase its
substitute.
Power Breaker
Padlock
(No. 2500 30 MM)
Precautionary Measures in Maintenance and
Inspection Work
Padlock
Main Valve
Section 1
Periodic Inspections
9910-001 1-1 Tg0249-PM-MM
Tg0249-PM-MM
0004-002 1-2
1. Periodic Inspection and Checking
This section describes how to perform lubrication and inspections work to
keep the machine in good working condition. It is recommended that lubrica-
tion and inspections work be performed periodically.
CAUTION
• Only qualified personnel should perform lubrication,
inspections, and cleaning work carefully in compliance
with the specified procedures.
• Be sure to turn off the main power of the machine,
shut off the air source, and lock the main switch with
the padlock before lubrication , inspections, and clean-
ing work.
Refer to “Precautionary Measures in Maintenance and
Inspection Work” for details.
• After cleaning with a rag, take the greatest care not to leave any waste
thread in order to avoid machine failure.
• Wipe off old grease before lubrication. If old grease is left, greasing will
be degraded.
• When air-blow is used to clean, do not blow air onto any unspecified
places. If scattered dirt or dust is accumulated on the various sensors, ball
screws or linear guides, etc., it might cause machine failure.
• If the recognition operation is performed with accumulated dirt and dust
on the protection glass or the teaching plate section of the recognition
camera, it will result in incorrect recognition.
• When a feeder (a tape feeder, a vibratory stick feeder, etc.) is replaced,
check the current feeder condition for damages, cracks, bends, etc. to
avoid breakdown and perform maintenance if necessary.
1. Periodic Inspection and Checking