4OM-1064-001 - 第149页

Tg0249-PM-MM 6.10 PICK-UP LOCA TION (T APE·VIB. STICK) Display • The offset teaching operation is performed on the pick-up location of the components to be supplied from the tape and vibratory stick feeders. When the [T …

100%1 / 274
Tg0249-PM-MM
*1 [TAPE VIB. STICK] Key
When this key is pressed, the “PICK-UP LOCATION (TAPE
VIB. STICK)”
display appears on the screen.
Perform the offset teaching operation on the following parameters through
manual alignment operation.
• PICK-UP LOCATION ADJUSTMENT X, Y in the component library
data
• FEEDER (B) OFFSET X and Y
• OFFSET X, Y in the component data
*2 [TRAY] Key (Option)
When this key is pressed, the “PICK-UP LOCATION (TRAY)” display
appears on the screen.
Note: This display cannot be opened while the pallet is being drawn out.
Perform the offset teaching operation on the following parameters through
manual alignment operation.
• PITCH X (mm), Y (mm) and SIDE LG. X (mm), Y (mm) in the compo-
nent library data
• FEEDER (B) OFFSET X and Y
• OFFSET X, Y and PICK-UP LOCATION ADJUSTMENT X, Y
9910-001 3-102
6. TEACH OFFSET Display
Tg0249-PM-MM
6.10 PICK-UP LOCATION (TAPE·VIB. STICK) Display
• The offset teaching operation is performed on the pick-up location of the
components to be supplied from the tape and vibratory stick feeders.
When the [TAPE
VIB. STICK] key is pressed at the “PICK-UP LOCATION”
display, the following display appears on the screen.
*7
*11
*2
*1
*3
*4
*12
*8 *9
*10
*6
*5
[TEACH ECC. PICKUP POS
[PICKUP LOC. ADJ]] Key
[TEACH PICK-UP POS. [COMP.
CENTER POS.]] Key
9910-001 3-103
6. TEACH OFFSET Display
Fig. 3.66-1
Fig. 3.66-2
Tg0249-PM-MM
*1 [FEEDER #] Key
When this key is pressed, the “PICK-UP LOCATION
TEACH - SET FEEDER” display (Fig. 3.67-1) appears on
the screen, enabling the setting of the feeder No. whose
pick-up location must be taught.
Procedure for Feeder Selection
(1) Select one of the keys A to specify the feeder base.
(2) Select the feeder No., using the [
] or the [ ] key B.
To teach the data related to the vibratory stick feeder,
select one of the keys C to specify the feeder carriage.
(3) Press the [SET] key.
*2 [
PREV. FEEDER #] and [ NEXT FEEDER #] Keys
The feeder Nos. registered in the component data of the
current program are scrolled up or down.
This function automatically skips the feeder Nos. which
are not specified in the current program or the feeder Nos.
for which no components are set in the component data.
[FDR. -A 101- ]
B
C
[101]
Fig. 3.67-1
A
Fig. 3.67-2
0004-002 3-104
6. TEACH OFFSET Display