Horizon UserManualV6 - 第102页
8. Select Exit (F8). Auto Dispense Manual Load Load Cart. Print Directn Exit Run a Product in Step Mode 1. Select Run (F1). Run Open Cover Paste Load Clean Screen Adjust Setup Monitor Maint. 2. Load a board on to the con…
4. Load the solder paste onto the screen.
5. Lower the front printhead cover.
6. Press the System button.
7. Select Continue (F1).
Continue
Software Version 6 User Manual 1.85
MACHINE PROGRAMMING
STAGE 7
WARNING
SOLDER PASTEAND SOLVENTS. WHEN USING OR HANDLINGAN
Y
SOLDER PASTE OR SOLVENT FORMULATION THE
MANUFACTURERS' RECOMMENDED SAFETY PRECAUTIONS
MUST BE STRICTLYADHERED TO.
8. Select Exit (F8).
Auto
Dispense
Manual
Load
Load
Cart.
Print
Directn
Exit
Run a Product in Step
Mode
1. Select Run (F1).
Run
Open
Cover
Paste
Load
Clean
Screen
Adjust Setup Monitor Maint.
2. Load a board on to the conveyor.
3. Select Auto Board (F1).
Auto
Board
Manual
Board
Knead
Paste
Exit
4. Select Step (F1).
Step
Open
Cover
Inspect
Setup
Single Exit
5. Select Step (F1).
Step
Open
Cover
Inspect
Setup
Single Exit
6. Select Step (F1).
Step
Open
Cover
Fiducial
Setup
Adjust Search
Step
Search
Reset
Single Exit
7. Select Step (F1).
Step
Open
Cover
Fiducial
Setup
Adjust Search
Step
Search
Reset
Single Exit
1.86 User Manual Software Version 6
MACHINE PROGRAMMING
STAGE 7
8. Select Step (F1).
Step
Open
Cover
Fiducial
Setup
Adjust Search
Step
Search
Reset
Single Exit
9. Select Step (F1).
Step
Open
Cover
Fiducial
Setup
Adjust Search
Step
Search
Reset
Single Exit
10. Select Step (F1).
Step
Inspect
Setup
Single Exit
11. Select Auto Board (F1).
Auto
Board
Manual
Board
Exit
12. Remove the board from the conveyor and inspect the print for alignment. If
the alignment is satisactory go to Step 16, if the alignment needs adjusting,
calculate the following:
X Offset, Y Offset and q Offset.
13. Select Edit Data (F3).
Mode Load
Data
Edit
Data
Setup
Squeegee
Change
Screen
Change
Tooling
Change
Language
Exit
14.
Enter the X Offset, Y Offset and q Offset, calculated in Step 12 to both the
Forward and Reverse set of offsets.
15. Repeat Steps 1 - 12 until the alignment is correct for both a forward and
reverse print.
16. If 2D Inspection is being used continue with Stage 9, if 2D Inspection isn’t
being used go to Stage 10.
Software Version 6 User Manual 1.87
MACHINE PROGRAMMING
STAGE 7