Horizon UserManualV6 - 第104页

STAGE 8 2Di Setup For a complete explanation of 2Di and its setup refer to the 2D Inspection Chapter. 1.88 User Manual Software Version 6 MACHINE PROGRAMMING STAGE 8

100%1 / 378
8. Select Step (F1).
Step
Open
Cover
Fiducial
Setup
Adjust Search
Step
Search
Reset
Single Exit
9. Select Step (F1).
Step
Open
Cover
Fiducial
Setup
Adjust Search
Step
Search
Reset
Single Exit
10. Select Step (F1).
Step
Inspect
Setup
Single Exit
11. Select Auto Board (F1).
Auto
Board
Manual
Board
Exit
12. Remove the board from the conveyor and inspect the print for alignment. If
the alignment is satisactory go to Step 16, if the alignment needs adjusting,
calculate the following:
X Offset, Y Offset and q Offset.
13. Select Edit Data (F3).
Mode Load
Data
Edit
Data
Setup
Squeegee
Change
Screen
Change
Tooling
Change
Language
Exit
14.
Enter the X Offset, Y Offset and q Offset, calculated in Step 12 to both the
Forward and Reverse set of offsets.
15. Repeat Steps 1 - 12 until the alignment is correct for both a forward and
reverse print.
16. If 2D Inspection is being used continue with Stage 9, if 2D Inspection isn’t
being used go to Stage 10.
Software Version 6 User Manual 1.87
MACHINE PROGRAMMING
STAGE 7
STAGE 8
2Di Setup For a complete explanation of 2Di and its setup refer to the 2D Inspection
Chapter.
1.88 User Manual Software Version 6
MACHINE PROGRAMMING
STAGE 8
STAGE 9
Running a Product
in Run Mode
1. Select Setup (F6)
Run Open
Cover
Paste
Load
Clean
Screen
Adjust
Setup
Monitor Maint.
2. Select Mode (F1) until Auto is indicated in the mode option on the screen.
Mode
Load
Data
Edit
Data
Setup
Squeegee
Change
Screen
Change
Tooling
Change
Language
Exit
3. Select Exit (F8).
Mode Load
Data
Edit
Data
Setup
Squeegee
Change
Screen
Change
Tooling
Change
Language
Exit
4. Select Run (F1). If squeegees are being used continue with Step 5, if
ProFlow is being used go to Step 19.
Run
Open
Cover
Paste
Load
Clean
Screen
Adjust Setup Monitor Maint.
5. During the first print stroke, when the squeegee is down printing on the
board, select Stop Cycle (F2). The print cycle stops and the printer lid bolt
releases allowing access to the print carriage.
End
Run
Stop
Cycle
Paste
Load
Clean
Screen
Adjust Knead
Paste
Adjust
Inspect
6. Lift the front printhead cover.
Software Version 6 User Manual 1.89
MACHINE PROGRAMMING
STAGE 9