Horizon UserManualV6 - 第316页

4. Remove the empty cartridge by unscrewing the cap at the rear of the paste dispense tube to allow it to be withdrawn. 5. Unscrew the nozzle from the old cartridge and insert it into the new cartridge. 6. Fit the new ca…

Fitting a New Paste

Cartridge

It is necessary at intervals to fit a new paste cartridge into the paste dispenser. If

there is no cartridge in the dispenser or the cartridge is empty, the warning

window ‘Print Medium Low. Please Replenish.’ is displayed.

If the consumable action option in set preferences is set to suspend, the paste

dispenser is checked to ensure availabilily of paste, before allowing a print run to

start. If paste isn’t available the warning window ‘Print Medium Low. Please

Replenish.’ is displayed.

To replace the paste cartridge carry out the following:

1. Press Paste Load (F3).

Run Open

Cover

Paste

Load

Clean

Screen

Adjust Setup Monitor Maint.

2. Press Load Cart. (F4).

Auto

Dispense

Manual

Load

Cart.

Directn

Exit

The print carriage drives to the front of the machine and the dispenser rises to the

vertical position. A message is displayed on the screen ‘Open cover and

replace Paste Cartridge’.

3. Open the front printhead cover.

Software Version 6 User Manual 9.15

CONSUMABLE REPLENISHMENTS

PASTE LOADING

WARNING

SOLDER PASTE AND SOLVENTS. WHEN USING OR HANDLINGAN

SOLDER PASTE OR SOLVENT FORMULATION THE

MANUFACTURERS' RECOMMENDED SAFETY PRECAUTIONS

MUST BE STRICTLYADHERED TO.

WARNING

PROTECTIVE CLOTHING. APPROVED PROTECTIVE CLOTHIN

SHOULD BE WORN BY SOLDER PASTE AND SOLVENT HANDLERS

AT ALL TIMES TO ELIMINATE FUME INHALATION, EYE

CONTACT, SKIN CONTACTAND INGESTION.

4. Remove the empty cartridge by unscrewing the cap at the rear of the paste

dispense tube to allow it to be withdrawn.

5. Unscrew the nozzle from the old cartridge and insert it into the new

cartridge.

6. Fit the new cartridge into the dispenser.

9.16 User Manual Software Version 6

CONSUMABLE REPLENISHMENTS

PASTE LOADING

7. Screw the end cap onto the dispenser finger tight. Ensure the pneumatic

fitting on the cap is facing towards the rear of the machine.

8. Close the front printhead cover.

9. Press the System button.

10. Press Exit (F8).

Auto

Dispense

Manual

Load

Cart.

Directn

Exit

Software Version 6 User Manual 9.17

CONSUMABLE REPLENISHMENTS

PASTE LOADING