Horizon UserManualV6 - 第326页
1. Remove the solvent tank cap (1) from the solvent tank (2). NOTE Numbers in brackets refer to figure below. 2. Using a suitable container refill the tank and replace the cap. 3. Close the front printhead cover. 9.26 Us…
20. Lift the front printhead cover.
21. If the paper roll is to be replenished continue with Step 22. If the solvent tank
only is to be replenished go to Solvent Replenishment section.
22.Remove the screen.
23 Go to Paper Replenishment section.
Solvent
Replenishment
Software Version 6 User Manual 9.25
CONSUMABLE REPLENISHMENTS
BLUE UNDERSCREEN CLEANER
WARNING
RECOMMENDED SOLVENTS. ANY SOLVENTS USED MUST
COMPLY WITH LOCAL ENVIRONMENTAL GUIDELINES. DE
K
RECOMMEND USING SOLVENTS THAT ARE ENVIRONMENTALL
Y
FRIENDLY, IE CFC FREE AND WATER BASED. SOLVENTS USED
MUST HAVE FAST EVAPORATION RATES AND FLASHPOINT
SPECIFICATIONS GREATER THAN 39 C.°
WARNING
SOLDER PASTE AND SOLVENTS. WHEN USING OR HANDLINGAN
Y
SOLDER PASTE OR SOLVENT FORMULATION THE
MANUFACTURERS' RECOMMENDED SAFETY PRECAUTIONS
MUST BE STRICTLYADHERED TO.
1. Remove the solvent tank cap (1) from the solvent tank (2).
NOTE
Numbers in brackets refer to figure below.
2. Using a suitable container refill the tank and replace the cap.
3. Close the front printhead cover.
9.26 User Manual Software Version 6
CONSUMABLE REPLENISHMENTS
BLUE UNDERSCREEN CLEANER
1
2
WARNING
SOLVENT SOLUTION. DO NOT MIX SOLVENT SOLUTIONS. FLUSH
THE SOLVENT TANK THOROUGHLY WHEN CHANGING TO
A
DIFFERENT SOLVENT SOLUTION.
WARNING
SOLVENT SPRAY. THE UNDERSCREEN CLEANER SPRAYS A FINE
JET OF SOLVENT SOLUTION ON TO THE CLEANER. APPROVED
PROTECTIVE CLOTHINGSHOULD BE WORN.
WARNING
PROTECTIVE CLOTHING. APPROVED PROTECTIVE CLOTHIN
G
SHOULD BE WORN BY SOLDER PASTE AND SOLVENT HANDLERS
AT ALL TIMES TO ELIMINATE FUME INHALATION, EYE
CONTACT, SKIN CONTACTAND INGESTION.
4. Press the System button.
5. Press Prime Solvent (F6) key.
Change
Screen
Board
Clamps
Prime
Paper
Prime
Solvent
Exit
The message ‘Press the two button control buttons to prime solvent.’ is
displayed.
6. Prime the solvent using the two button control.
7. Press Exit (F8).
Change
Screen
Board
Clamps
Prime
Paper
Prime
Solvent
Exit
Paper
Replenishment
NOTE
When using 300 or 400mm wide paper rolls, ensure the correct paper roll
spacers are used.
Software Version 6 User Manual 9.27
CONSUMABLE REPLENISHMENTS
BLUE UNDERSCREEN CLEANER
WARNING
PROTECTIVE CLOTHING. APPROVED PROTECTIVE CLOTHIN
G
SHOULD BE WORN BY SOLDER PASTE AND SOLVENT HANDLERS
AT ALL TIMES TO ELIMINATE FUME INHALATION, EYE
CONTACT, SKIN CONTACTAND INGESTION.
WARNING
FLAMMABLE. THE USED PAPER ROLL CONTAINS RESIDUES O
F
UNDERSCREEN CLEANER FLUID AND SOLDER PASTE. OBSERVE
MANUFACTURERS' RECOMMENDED DISPOSALINSTRUCTIONS.