Horizon UserManualV6 - 第50页
38. Close the front printhead cover. 39. Press the System button. 40. Select Change Screen (F2). Adjust Change Screen Board Clamps Set Stop Exit 41. Select Exit (F8). Adjust Change Screen Board Clamps Set Stop Exit 42. S…
33. Select Open Cover (F2).
Adjust
Open
Cover
Remove
Cleaner
Board
Stop
Full
Width
Load
Width
Print
Height
Exit
34. Lift the front printhead cover.
35. Select Board Clamps (F3), to open the clamps.
Adjust
Board
Clamps
Set
Stop
Exit
36. Remove the board from the rails.
37. Load the appropriate stencil for the product file loaded, ensuring the correct
orientation of the stencil.
Software Version 6 User Manual 1.33
MACHINE PROGRAMMING
STAGE 5A
38. Close the front printhead cover.
39. Press the System button.
40. Select Change Screen (F2).
Adjust
Change
Screen
Board
Clamps
Set
Stop
Exit
41. Select Exit (F8).
Adjust Change
Screen
Board
Clamps
Set
Stop
Exit
42. Select Exit (F8).
Adjust Open
Cover
Remove
Cleaner
Board
Stop
Full
Width
Load
Width
Print
Height
Exit
43. Go to Stage 6.
1.34 User Manual Software Version 6
MACHINE PROGRAMMING
STAGE 5A
STAGE 5B
Tooling Setup -
Vacuum
CAUTION
BOARD CLAMPS. Care must be taken to ensure that the board clamps
are not damaged when removing or replacing tooling.
1. Select Change Screen (F5).
Mode Load
Data
Edit
Data
Setup
Squeegee
Change
Screen
Change
Tooling
Change
Language
Exit
The message ‘Open Front Cover and Remove Screen’ is displayed.
2. Open the front printhead cover.
3. Remove the stencil from the printer.
Software Version 6 User Manual 1.35
MACHINE PROGRAMMING
STAGE 5B
WARNING
BOARD CLAMPS. EXTREME CARE MUST BE EXERCISED WHEN
WORKING IN THE TOOLING AREA OF THE MACHINE TO AVOID
INJURY. THE FOILS ON THE FRONT AND REAR BOARD CLAMPS
ARE VERY SHARP.