Horizon UserManualV6 - 第68页
40. Lower the front printhead cover. 41. Press the System button. 42. Select Change Screen (F2). Adjust Change Screen Board Clamps Set Stop Exit 43. Select Exit (F8). Adjust Change Screen Board Clamps Set Stop Exit 44. S…
34. Select Home Position (F7).
Open
Cover
Home
Position
Exit
35. Select Open Cover (F2).
Adjust
Open
Cover
Remove
Cleaner
Board
Stop
Full
Width
Load
Width
Print
Height
Exit
36. Lift the front printhead cover.
37. Select Board Clamps (F3), to open the clamps.
Adjust
Board
Clamps
Set
Stop
Exit
38. Remove the board from the rails.
39. Load the appropriate stencil for the product file loaded, ensuring the correct
orientation of the stencil.
Software Version 6 User Manual 1.51
MACHINE PROGRAMMING
STAGE 5C
40. Lower the front printhead cover.
41. Press the System button.
42. Select Change Screen (F2).
Adjust
Change
Screen
Board
Clamps
Set
Stop
Exit
43. Select Exit (F8).
Adjust Change
Screen
Board
Clamps
Set
Stop
Exit
44. Select Exit (F8).
Adjust Open
Cover
Remove
Cleaner
Board
Stop
Full
Width
Load
Width
Print
Height
Exit
45. Go to Stage 6.
1.52 User Manual Software Version 6
MACHINE PROGRAMMING
STAGE 5C
STAGE 5D
Tooling Setup -
MultiFlex
CAUTION
BOARD CLAMPS. Care must be taken to ensure that the board clamps
are not damaged when removing or replacing tooling.
NOTE
Setting up the MultiFlex tooling is to be performed off the machine.
1. Create a box the same size as the board using the side plates.
2. Use the board width and board length dimensions to position the box
correctly.
3. Place the PCB on a flat surface, component side up.
4. Position the acetate template, supplied with the tooling, over the PCB such
that the front edge of the board is aligned with the arrow indicators on the
template. Ensure that the centreline of the board is aligned with the template
zero.
Software Version 6 User Manual 1.53
MACHINE PROGRAMMING
STAGE 5D
WARNING
BOARD CLAMPS. EXTREME CARE MUST BE EXERCISED WHEN
WORKING IN THE TOOLING AREA OF THE MACHINE TO AVOID
INJURY. THE FOILS ON THE FRONT AND REAR BOARD CLAMPS
ARE VERY SHARP.