Horizon UserManualV6 - 第80页
4. Close the front printhead cover. 5. Press the System button. 6. Select Change Tooling (F6). Mode Load Data Edit Data Setup Squeegee Change Screen Change Tooling Change Language Exit The print carriage and the under sc…
STAGE 5E
Tooling Setup-
AutoFlex
The correct pins for each product are selected automatically when the board size
parameters are programmed into the product file. If the pin configuration needs
to be amended, for example if a support pin coincides with the position of an
underside component and needs to be removed, from the setup page:
CAUTION
BOARD CLAMPS. Care must be taken to ensure that the board clamps
are not damaged when removing or replacing tooling.
1. Select Change Screen (F5).
Mode Load
Data
Edit
Data
Setup
Squeegee
Change
Screen
Change
Tooling
Change
Language
Exit
The message ‘Open Front Cover and Remove Screen’ is displayed.
2. Open the front printhead cover.
3. Remove the stencil from the printer.
Software Version 6 User Manual 1.63
MACHINE PROGRAMMING
STAGE 5E
WARNING
BOARD CLAMPS. EXTREME CARE MUST BE EXERCISED WHEN
WORKING IN THE TOOLING AREA OF THE MACHINE TO AVOID
INJURY. THE FOILS ON THE FRONT AND REAR BOARD CLAMPS
ARE VERY SHARP.
4. Close the front printhead cover.
5. Press the System button.
6. Select Change Tooling (F6).
Mode Load
Data
Edit
Data
Setup
Squeegee
Change
Screen
Change
Tooling
Change
Language
Exit
The print carriage and the under screen cleaner are moved to the rear.
The Change Tooling Parameters window is displayed:
The parameters are not active.
7. Select Adjust (F1). The parameters are now active.
Adjust
Open
Cover
Home
Cleaner
Board
Stop
Full
Width
Load
Width
Print
Height
Exit
1.64 User Manual Software Version 6
MACHINE PROGRAMMING
STAGE 5E
Change Tooling Parameters
BOARD WIDTH
BOARD STOP X
BOARD STOP Y
216.0
125.0
142.6
mm
mm
mm
8. Select Change Autoflex (F1).
Change
Autoflex
Save Next Previous Incr. Decr. Exit
The Autoflex Matrix window is displayed:
The Autoflex pin matrix has already been setup for this product from the board
dimensions.
9. Use the Left, Right, Up and Down keys (F4 - F7), to select the pin positions
required for editing.
Lower Raise Reset
Left Right Up Down
Exit
10. Use the Lower and Raise keys (F1 - F2), to select or deselect the pins.
Lower Raise
Reset Left Right Up Down Exit
11. Select Exit (F8).
Lower Raise Reset Left Right Up Down
Exit
12. Select Save (F2).
Change
Autoflex
Save
Next Previous Incr. Decr. Exit
Software Version 6 User Manual 1.65
MACHINE PROGRAMMING
STAGE 5E
Autof
l
ex Matr
i
x
14
13
12
11
10
9
8
7
6
5
4
3
2
1
A
B
C
D
E
F
G
H
I
J
K
L
M
N
O
---------------
---------------
---------------
---------------
---------------
---------------
---------------
---------------
---------------
---------------
---------------
---------------
---------------
---------------