00197975-06_UM_TX-Serie_EN - 第271页

User manual SIPLACE TX-Series 5 Tasks at the placement machine From software version 713.0 Edition 01/2020 5.13 Avoiding track e rrors 271 5.13 A voiding track errors 5.13.1 General  Make sure that the are as around th …

5 Tasks at the placement machine User manual SIPLACE TX-Series

5.12 Changing the setup From software version 713.0 Edition 01/2020

270

5.12 Changing the setup

5.12.1 Printing out the conversion instructions before changing the setup

Before a change of setup, print out the conversion instructions on the printer for the SIPLACE Pro

computer as described in the "SIPLACE Pro" manual or in the online help.

5.12.2 What you should note when changing the feeder modules

 Handle the feeder modules carefully when you insert them into or remove them from the

changeover table. Make sure that the X feeder modules do not bump against the centering

bar (see item 5 in fig. 5.10 - 3

, page 260) of the changeover table.

 Vacuum the supporting surfaces of the feeder modules and clean the surface of the table

when necessary according to the instructions in the preventive maintenance manual.

 Remove loose components using a brush or a vacuum cleaner with a suitable nozzle.

CAUTION

Risk of injuries!

Fine metal splinters from components could injure hands.

 Avoid removing components from the changeover table with your fingers.

User manual SIPLACE TX-Series 5 Tasks at the placement machine

From software version 713.0 Edition 01/2020 5.13 Avoiding track errors

271

5.13 Avoiding track errors

5.13.1 General

 Make sure that the areas around the feeder modules are clean and that there are no loose

components in the feeder area or under the feeder modules.

 Refill promptly with components.

 With tape feeder modules, make sure that you always splice on a new tape early enough so

that the feeder modules do not run out of components.

 However, do not splice the tapes too early because if you wind the tape onto the new reel

after splicing the end of the old tape, the reel with the new tape may be overfilled. The tape

could then slip off the reel and become tangled. Under certain circumstances, this could

cause pick-up errors and prolonged down times.

 Splice the tapes early. This generally means that you are to prepare the splicing material

when there is still approximately 1.5 m of tape on the reel.

 Handle the feeder modules carefully when you insert them into or remove them from the

changeover table as these are high-precision devices.

 For X feeder modules, lower the pickup window since it can easily be damaged when raised.

 Check that the pick-up position is set correctly for the components on the feeder modules.

 Check whether the separating plates have been correctly inserted.

PLEASE NOTE

The online help contains information on refilling components with and without barcodes.

PLEASE NOTE

A raised pick-up window leads to noticeably impaired pick-up quality.

5 Tasks at the placement machine User manual SIPLACE TX-Series

5.13 Avoiding track errors From software version 713.0 Edition 01/2020

272

5.13.2 Component coordinate system and pickup angle

Fig. 5.13 - 1 Position of the component and its pick-up angle

Special

component

Stick

magazine:

Chip-

components

with polarity

0402

2220

The anode must be

aligned with the +X

coordinate.

Package form 0° coordinate system

Position in the feeder module

Pickup angle/

nozzle angle

Tape:

SOT 23

Stick

magazine:

Tape:

SO-IC

DIL-IC

SOT 194

Tape:

Holes

90°

0°

90°

-90°

0°