00193365-0202 - 第19页
Retrofit instructions Splice sensors 8 - 72 mm 07/2003 Edition 19 3.5 Prep aratory work : Read the re trofit i nstru ctions and familiarize yourself wi th the splice s ensor for 2x8 mm or 3x8 mm feeder s. 3 Fig. 3 - 1 Sp…
Retrofit instructions Splice sensors 8 - 72 mm
07/2003 Edition
18
3.4 Safety instructions
3
DANGER
The splice sensor retrofit, including all the work described below, must only be carried out by
SIPLACE service engineers. 3
The safety instructions from the “Operational safety” chapter of the user manual and the service
manual take precedence over these instructions. 3
The placement machines are supplied with 3 x 400 VAC ± 10 %, 50/60 Hz main power voltage.3
Consequently parts of these systems inside the machine frame carry dangerous voltages, even
when switched off at the main switch. 3
Always follow the accident prevention regulations, DIN or other standards and special safety rules
applicable in your country. Always follow DIN EN 60204 and DIN VDE 105-100 when working in-
side the machine tool table. 3
Pay attention to the information concerning residual voltages in the Operational Safety chapter.3
Remember to follow the ESD regulations (see chapter Operational safety). 3
3
3
: Remove the feeder from the component table and detach the connecting cable before starting
work.
3
3
3
3
3
3
3
3
3
3
3
Retrofit instructions Splice sensors 8 - 72 mm
07/2003 Edition
19
3.5 Preparatory work
: Read the retrofit instructions and familiarize yourself with the splice sensor for 2x8 mm or 3x8
mm feeders.
3
Fig. 3 - 1 Splice sensors for 8 mm feeders
3.6 Installation
: Open the protective cover.
: Remove the 2x8 mm or 3x8 mm feeder from the machine.
3
Fig. 3 - 2 2x8 mm feeder
3
Splice sensor 2x8 mm
Splice sensor 3x8 mm
Retrofit instructions Splice sensors 8 - 72 mm
07/2003 Edition
20
: Remove the tape guide plate from the feeder.
3
Fig. 3 - 3 Unscrewing the tape guide plate
3
: Fix the tape guide plate to the sensor block using the same screw.
3
Fig. 3 - 4 Fixing the tape guide plate
3
3
3