M20_Ope_E - 第36页

Chapter 1 General 1-18 1-3-1 Sub-menu icon creation You can create a sub-menu icon. Creating an icon for frequently used sub-menu will ensure the convenient operation. Main menu [Management] Sub menu Sub menu Main menu […

100%1 / 518
Chapter 1 General
1-17
1-3 Menu Views
Note: When you move the pointer over the Main menu, corresponding sub-menu will appear on the relevant
button, and it will disappear when you move the pointer away. By clicking the button on Main menu bar,
the sub-menu display is fixed.
Main menu
Main menu
[Manual]
Sub menu
Sub menu
Sub menu
Main menu
[Tool]
Chapter 1 General
1-18
1-3-1 Sub-menu icon creation
You can create a sub-menu icon. Creating an icon for frequently used sub-menu will ensure the
convenient operation.
Main menu
[Management]
Sub menu
Sub menu
Main menu
[System]
Drag and drop a desired sub
menu to create an icon.
You can also change the icon
layout.
Right-click to delete a
desired icon.
Chapter 1 General
1-19
1-3-2 Overviews of Menu Commands
Main menu bar Sub-menu
Moves a specified axis manually for
checking its movement.
Allows specified axis/axes to return to
its/their origin.
Performs warm-up and self-checking.
Nozzle information screen will open.
Allows to check each actuator (air-drive
unit) movement and to measure its timing.
Loads a board to the mounter.
Signal I/O screen will open. Allows
checking digital Input/Output status.
Displays the condition of each PCB
sensors.
Allows to measure air pressure value for
each head.
Allows performing Jog operation or
Origin Initialization for W-axis of Auto
Conveyor Width
Checks the stocker for pallet presence, and
moves a specified pallet in and out on
CTF-40(OP).
(These commands here are mainly for
maintenance, which may not be used
normally.)
Shuts Off power to Servo-motors or
Feeder-bank individually.
Performs Open/Close test of ANC
Shutter.
Performs Illumination test of Teaching
Camera.
Checks each Feeder’s operation on Feeder
bank.
Checks Nozzle Scan function.
Checks pickup point of each feeder (ST
Origin).
Specifies feeder type to be used for
manual feeder operation. (Necessary for
PS-32A feeder)
Checks conveyor repeatability.
Checks each switch operation. After
performed, machine system needs to be
restarted.
Checks Intelligent feeder’s operation such
as LED illumination status etc.
Reminds you to do necessary
maintenances at fixed time intervals.