M20_Ope_E - 第433页
Chapter 15 Data 15-4 Nozzle Application Chart It is suggested that the most re commended (◎) nozzle should be used in case more than one nozzle are applicable. (Table 2) Recommended Level (High → Low): ◎ → ○ → △
Chapter 15 Data
15-3
Nozzle Edge Shape
Fig. 1 in the next page shows the edge shape of each nozzle and dimensions.
Chapter 15 Data
15-4
Nozzle Application Chart
It is suggested that the most recommended (◎) nozzle should be used in case more than one
nozzle are applicable. (Table 2)
Recommended Level (High → Low): ◎ → ○ → △
Chapter 15 Data
15-5
<Reference>
Standard nozzles in the above table are classified into the following 4 types by edge shape.
① Rectangular Nozzle: P050, P051, P052, P053, P061, P062
Suitable for most of chip components
② Round Nozzle without suction pad: P054, P055, P056, P057
Suitable for components of □ 4mm to □ 15mm size
③ Round Nozzle with suction pad: P017, P018, P019, P020
Suitable for components of □5mm or larger size for which vacuum pressure is difficult to rise
④ Nozzle for melf only: P072,P073
Suitable for melf components of Φ 1.0mm to Φ 2.2mm size
* １ : P050 for 01005(0402)R and 01005(0402)C only
* ２ : P051 for 0201(0603), P061 for 0201(0603) to 0402(1005)
* ３ : P052 for 0402(1005) to 0603(1608), P062 for 0603(1608) to 1206(3216)
* ４ : P053 for 0805(2012) to 1210(3225)
* ５ : P072 for melf of Φ 1.0mm to Φ1.1mm
* ６ : P073 for melf of Φ 1.2mm to Φ2.2mm