M20_Ope_E - 第509页
Chapter 16 Dispenser 16-39 ② Align the tube joint's pin with the car tridge body joint's U-cut, then connect them and partially tighten the nut by hand. Note: When connecting, the outer circumference of th e O-…
Chapter 16 Dispenser
16-38
16-5-2-5 Attaching the tube joint
Action:
① Attach the O-ring at the cartridge body side of the assembled tube joint.
Attach the O-ring to
the tube joint.
O-ring
Cartridge
body
Tube
Tube joint
O-ring
Chapter 16 Dispenser
16-39
② Align the tube joint's pin with the cartridge body joint's U-cut, then connect them and
partially tighten the nut by hand.
Note: When connecting, the outer circumference of the O-ring can be easily damaged by rubbing.
To prevent this, apply a light coating of grease to the O-ring's outer circumference before connecting.
Note: After installing a screw type dispense head on the mounter, use a torque wrench (spanner type: 14mm x
5Nm) to perform final tightening of the nut (explained in detail later).
Partially tighten this nut.
Tube joint's pin
U-cut at cartridge
body side joint
Chapter 16 Dispenser
16-40
- - - Blank P
a
ge - - -