M20_Ope_E - 第510页
Chapter 16 Dispenser 16-40 - - - Blank P a ge - - -
Chapter 16 Dispenser
16-39
② Align the tube joint's pin with the cartridge body joint's U-cut, then connect them and
partially tighten the nut by hand.
Note: When connecting, the outer circumference of the O-ring can be easily damaged by rubbing.
To prevent this, apply a light coating of grease to the O-ring's outer circumference before connecting.
Note: After installing a screw type dispense head on the mounter, use a torque wrench (spanner type: 14mm x
5Nm) to perform final tightening of the nut (explained in detail later).
Partially tighten this nut.
Tube joint's pin
U-cut at cartridge
body side joint
Chapter 16 Dispenser
16-40
- - - Blank P
a
ge - - -
Chapter 17 Multi Conveyor
17-1
Chapter 17
Multi Conveyor
Multi Conveyor Outline
Pa
rameter Setti
ngs
PCB Data
Manual Op
erat
ion