ELA Installation.pdf - 第33页
MACHI NE PRE PARAT ION REMOVAL PROC EDURES Chapter Issu e 3 Jun 01 Installati on Manua l 5.7 Actuator Restrainer Brackets CAUTION INSTALLING/REMO VING SCR EEN ACTUATOR BRACKETS. Extr eme care must be taken when installin…
MACHINE PREPARATION
REMOVAL PROCEDURES
5.6 Installation Manual Chapter Issue 3 Jun 01
Paste Dispense Transit Bracket
Figure 5-4 Paste Dispenser Transit Bracket
1. Remove the M5 cap head screw, M5 washer (Items 4, 3 and 6) and M5 nut
securing the left hand side of the transit bracket (Item 5) to the paste low
sensor mounting bracket (Item 2).
2. Remove the remaining M5 cap head screw and M5 washer (Items 4 and 3)
securing the right hand side of the transit bracket (Item 5) to the paste
dispenser and remove the transit bracket.
Item Description Item Description
1 Paste Dispenser 4 M5 Cap Head Screw
2 Paste Low Sensor Mounting Brackets 5 Paste Dispenser Transit Bracket
3 M5 Washer 6 M5 Nut (concealed from view)
MACHINE PREPARATION
REMOVAL PROCEDURES
Chapter Issue 3 Jun 01 Installation Manual 5.7
Actuator Restrainer Brackets
CAUTION
INSTALLING/REMOVING SCREEN ACTUATOR BRACKETS.
Extreme care must be taken when installing or removing the screen actua-
tor clamps as the chase is spring loaded against the screen actuator ends in
the X Forward, X Rear and Y Axis Positions. Impact force may damage the
actuators.
Figure 5-5 Chase Restrainer Clamp
1. Slowly loosen the M8 nuts and bolts (Items 5 and 4) of the X forward, X rear
and Y axis chase restrainer clamps until each actuator is in full contact with
its relevant chase striker plate (Item 8).
2. On each of the three clamps, continue to unscrew the M8 nut (Item 5) until
sufficient play exists in the clamp to allow the block (Item 7) surrounding the
chase striker plate (Item 8) to be withdrawn and the clamp removed.
Item Description Item Description
1 Actuator Shaft 5 M8 Nut
2 Restrainer Collar 6 M8 Washer
3 Actuator 7 Block
4 M8 Bolt 8 Striker Plate
MACHINE PREPARATION
REMOVAL PROCEDURES
5.8 Installation Manual Chapter Issue 3 Jun 01
Print Carriage Stops
Figure 5-6 Left and Right Print Carriage Stops
1. Remove the M5 cap head screws and 2BA washers securing the left and right
print carriage stops to the print carriage.
2. Remove the M5 cap head screws and 2BA washers securing the left and right
print carriage stops to the printhead casting lugs. Remove the carriage stops.
Left Carriage Stop Right Carriage Stop
M5 Screw2BA Washer