3OM-1064-001 - 第198页

1. T rouble Shooting after Recognition Error 0005-002 4-2 Tg0248-PM-ER 1. T rouble Shooting after Recognition Error Recognition Error Indication Examples A: Shows an ERROR message. B: Shows the ERROR description. C: Indi…

Section 4

Recognition Error Codes

0005-002 4-1 Tg0248-PM-ER

1. Trouble Shooting after Recognition Error

0005-002 4-2 Tg0248-PM-ER

1. Trouble Shooting after Recognition Error

Recognition Error Indication Examples

A: Shows an ERROR message.

B: Shows the ERROR description.

C: Indicates the Cause and Remedy of Error

(There are some errors for whichthe indication may not be displayed).

H: Shows the recognition error code consisting of 8 digits.

Fig. 4.1

0005-002 4-3 Tg0248-PM-ER

Check “Section H indication (Recognition Error Code)”, “Section A Indica-

tion”, “Section B Indication”, and “Section C Indication” at the Recognition

Error Display, and reset the device while referring to the following trouble

shooting guide.

*1: Shows a recognition error code.

The codes are indicated in their order of code No.

*2: Shows the description of “Section A Indication” for the recognition error

code.

*3: Shows the description of “Section B Indication” for the recognition error

code.

*4: Shows the “Cause” and “Remedy” for the recognition error code.

Note: The description might be different from that in the “CAUSE AND

REMEDY” column of the RECOGNITION ERROR display.

*5: When the description is continued on to the next page, “NEXT PAGE” is

indicated.

*6: Icons

: Indicats the cause of the error.

: Indicates the work procedure.

: Contact our service personnel.

: Shows the teaching function.

(Cause 1) Motor encoder section may be defective.

(Cause 2) Encoder cable may be broken.

(Reset Procedure in the case of Causes 1 and 2)

Reset Procedure

(1) Turn off the power and check for loose connections between the sections of the motor and

signal cable.

(2) Re-start.

(3) If the device can’t be reset even after the above check, contact our service personnel because

the signal cable may be broken or the motor may be defective.

Error Code Display A Display B

(Cause 1) The sensor may be defective.

(NEXT PAGE)

00XXXXXX INSI D E R ECOGNITION DATA UNUSUALLY OCCURRED INSIDE A RECOGNI-

TION.

00XXXXXX DI S PL AY A TH R OU G H I MA G E “CAMERA NO.” EXCEEDS THE RANGE OF SETTING.

*1 *2 *4 *3

*5 *3

Indication Example

1. Trouble Shooting after Recognition Error