00198442-01_UM_TX-V2_EN - 第151页
User manual SIPLACE TX V2 3 Technical data and assemblies From software version 711.1 04/2018 3.9 Component trolley 151 3.9.4 SIPLACE TX-Series changeover t able The front slider guides of the feed er modules are pl aced…
3 Technical data and assemblies User manual SIPLACE TX V2
3.9 Component trolley From software version 711.1 04/2018
150
3.9.3 Fiducials on the SIPLACE TX-Series component trolley
3
Fig. 3.9 - 3 Fiducials on the SIPLACE TX-Series component trolley
(1) Fiducials on the component trolley
Once the SIPLACE TX component trolley has been docked in, the placement machine measures
the fiducials on the component trolley.
In the case of components with an edge length less than 0.5 mm, meaning 0402 components and
smaller, the position of the component is determined with the tape pocket, when the setup is spec-
ified or when the start button is pressed after the table or feeder has been removed.
(1)
User manual SIPLACE TX V2 3 Technical data and assemblies
From software version 711.1 04/2018 3.9 Component trolley
151
3.9.4 SIPLACE TX-Series changeover table
The front slider guides of the feeder modules are placed on the insertion aid. As it is pushed in,
the guides of the feeder module slide on the guide profile as far as the stop bar. A centering hole
on the stop bar holds the "front" centering pin of the X feeder module. At the same time, the locking
latch of the changeover table latches onto the locking roller of the feeder module. The "back" cen-
tering pin on the top of the feeder module is held by the recess in the centering bar.
3
Fig. 3.9 - 4 Changeover table, SIPLACE TX-Series, rear view
(1) Insertion aid
(2) Guide profile (Ω profile)
(3) Centering bar for holding the "back" centering pin for X feeder modules
(4) Centering holes
(5) Stop bar
(1)
(2)
(3)
(4)
(5)
3 Technical data and assemblies User manual SIPLACE TX V2
3.9 Component trolley From software version 711.1 04/2018
152
3
Fig. 3.9 - 5 Changeover table, SIPLACE TX-Series, front view
(1) Centering hole on the changeover table
(2) Locking latches
(3) Centering pin on the changeover table
(1)
(2)
(3)