00198442-01_UM_TX-V2_EN - 第162页
4 Setting up and commissioning User manual SIPLACE TX V2 4.2 Configuration when delivered From software version 711.1 04/2018 162 4.2.6 Lif ting the placement machine off the pallet 4 Fig. 4.2 - 3 Contact points for tran…
User manual SIPLACE TX V2 4 Setting up and commissioning
From software version 711.1 04/2018 4.2 Configuration when delivered
161
4.2.5.2 Weight of machine when ready for dispatch
The following table contains the weights of the placement machines prepared for dispatch, includ-
ing packaging.
4
4.2.5.3 Transportation equipment for transporting the placement machine in the packaging
Use a fork-lift truck with the following specification to carry the placement machine:
4
Machine Dispatch within Europe Dispatch overseas
SIPLACE TX with two component trol-
leys
2350 kg 2600 kg
Fork length Min. 1800 mm
Lifting power Min. 3000 kg
4 Setting up and commissioning User manual SIPLACE TX V2
4.2 Configuration when delivered From software version 711.1 04/2018
162
4.2.6 Lifting the placement machine off the pallet
4
Fig. 4.2 - 3 Contact points for transportation with the fork-lift
(1) Shipping braces with steel spacer
During transportation, always follow the safety instructions in section 4.1, page 155).
Loosen the two shipping braces (1) on the pallet. The two braces and the steel spacers re-
main fitted to the placement machine.
Loosen and remove the shipping braces on the opposite side (item 2 in fig. 4.2 - 1, page 159).
The machine may ONLY be lifted with a fork-lift on the side (item A in fig. 4.2 - 3, page 162)
on which the output end of the machine is located.
(A)
1
1
User manual SIPLACE TX V2 4 Setting up and commissioning
From software version 711.1 04/2018 4.2 Configuration when delivered
163
4
Fig. 4.2 - 4 Contact surfaces - Forks parallel to the direction of PCB transport on the output side
(T) Direction of travel for PCB conveyor
(1) Fork-lift forks between the machine feet
(2) Never lift the machine at the input side! Risk of tilting!
(3) Never lift the machine at the component trolley locations with a fork-lift! Risk of tilting!
(4) Shipping braces with steel spacer
Position the fork-lift at cross-angles to the direction of conveyor transport (at the output end).
Open the forks until the forks are between the two placement machine feet and the contact
surfaces of the placement machine lie evenly on the forks.
Push the forks between the contact surfaces of the placement machine (machine frame) and
over the steel spacers for the shipping braces. The steel spacers are used as an additional
safety measure to prevent the placement machine from tilting.
Push the forks fully under the placement machine, so that these are positioned properly on
the machine frame of the opposite side.
Lift the placement machine off the pallet.
(2)
(1)
(3)
(3)
(4)
(4)