00198442-01_UM_TX-V2_EN - 第251页
User manual SIPLACE TX V2 5 Tasks at the placement machine From software version 711.1 04/2018 5.15 Docking the component trolley in or out 253 5.15.2 Docking the component trolley 5 5 5 Carefully push the component tr…
5 Tasks at the placement machine User manual SIPLACE TX V2
5.15 Docking the component trolley in or out From software version 711.1 04/2018
252
5
Fig. 5.15 - 1 Safety instructions for docking and undocking the component trolley (example of location 2)
(1) Button for docking and undocking the component trolley at location 2
(2) Handles
(T) Direction of PCB transport
(1)
(2)
User manual SIPLACE TX V2 5 Tasks at the placement machine
From software version 711.1 04/2018 5.15 Docking the component trolley in or out
253
5.15.2 Docking the component trolley
5
5
5
Carefully push the component trolley into the placement machine as far as the stop.
Press the button on the respective placement machine location until the trolley is completely
docked in.
CAUTION
Pushing in component trolley!
When pushing the component trolley into the placement machine, make sure that
you do not hit obstacles with the locking latches.
PLEASE NOTE
Cut tapes flush
If you do not cut tapes off flush at the front end of the X feeder modules, the emptied
tapes will not enter the empty tape duct.
Cut the tapes off flush, before you dock the component trolley into place.
CAUTION
Position of placement head!
Check that the placement head is outside the range of the component trolley.
5 Tasks at the placement machine User manual SIPLACE TX V2
5.15 Docking the component trolley in or out From software version 711.1 04/2018
254
5.15.3 Safety instructions for moving the component trolley
5
Always hold the handles with both hands when you want to move the component trolley.
Remember that a component trolley with the full complement of feeder modules can tip over
sideways or forward on gradients of 20° or more.
Make sure that the surface on which the trolley is moved has a significantly smaller gradient.
Be careful not to collide with obstacles. The trolley could tip forward if it is traveling fast
enough.
5.15.4 Docking out the component trolley
Switch the control system "Off".
Press the button on the respective placement machine location until the component trolley is
completely undocked.
With both hands on the handles, pull the component trolley out of the placement machine.
WARNING
Avoid accidents!
To prevent accidents, ALWAYS follow the rules listed below when you move the compo-
nent trolley.