00198442-01_UM_TX-V2_EN - 第252页

5 Tasks at the placement machine User manual SIPLACE TX V2 5.15 Docking the component trolley in or out From software ver sion 711.1 04/2018 254 5.15.3 Safety instructions for moving the co mponent trolley 5  Always hol…

User manual SIPLACE TX V2 5 Tasks at the placement machine

From software version 711.1 04/2018 5.15 Docking the component trolley in or out

253

5.15.2 Docking the component trolley

 Carefully push the component trolley into the placement machine as far as the stop.

 Press the button on the respective placement machine location until the trolley is completely

docked in.

CAUTION

Pushing in component trolley!

 When pushing the component trolley into the placement machine, make sure that

you do not hit obstacles with the locking latches.

PLEASE NOTE

Cut tapes flush

If you do not cut tapes off flush at the front end of the X feeder modules, the emptied

tapes will not enter the empty tape duct.

 Cut the tapes off flush, before you dock the component trolley into place.

CAUTION

Position of placement head!

Check that the placement head is outside the range of the component trolley.

5 Tasks at the placement machine User manual SIPLACE TX V2

5.15 Docking the component trolley in or out From software version 711.1 04/2018

254

5.15.3 Safety instructions for moving the component trolley

 Always hold the handles with both hands when you want to move the component trolley.

 Remember that a component trolley with the full complement of feeder modules can tip over

sideways or forward on gradients of 20° or more.

 Make sure that the surface on which the trolley is moved has a significantly smaller gradient.

 Be careful not to collide with obstacles. The trolley could tip forward if it is traveling fast

enough.

5.15.4 Docking out the component trolley

 Switch the control system "Off".

 Press the button on the respective placement machine location until the component trolley is

completely undocked.

 With both hands on the handles, pull the component trolley out of the placement machine.

WARNING

Avoid accidents!

To prevent accidents, ALWAYS follow the rules listed below when you move the compo-

nent trolley.

User manual SIPLACE TX V2 6 Station extensions

From software version 711.1 04/2018 6.1 Nozzle changer

257

6 Station extensions

For the relevant configurations and other options, refer to the individual specifications for the SI-

PLACE placement machines.

6.1 Nozzle changer

The nozzle changer is available in two variants for the relevant head type:

– Short nozzle changer with 4 magazines and 20 nozzle garages each for the

SIPLACE TX1_V2/TX2 V2

– Narrow nozzle changer with 3 magazines and 20 nozzle garages each for the

SIPLACE TX2i V2

The magazines are seated on a common support. They are centered with two parallel pins and

fixed in place with 4 push buttons. The exact position is determined with two fiducials on each

magazine. The correct seat of the magazines on the basic nozzle changer body is monitored by

microswitches, to prevent a collision of the placement head with any magazines projecting up-

wards. All magazine locations must be filled since the safety circuit stops the placement machine

in response to missing magazines or magazines that are not seated correctly. At the installed noz-

zle station, components can be blown off the nozzles of the SpeedStar and nozzles stripped off

and rejected.