N7201A652E - 第20页
NPM- TT2 EJM1EE-SF-01N-05 1-1 -3 Do not disable safety switches (Risk of i njury) Replenis h-section open/close switch ● It has a function of safety switch ● Installed under the cover Safety switch (In the magazine door)…
NPM-TT2 EJM1EE-SF-01N-05
1-1-2
To prevent
injury or
burn…
Emergency stop switch
(Located in front and rear)
Be sure to observe the following
■For several machines connected
If you sense any danger or abnormalities,
press the emergency stop switch to stop
operation
●When you push the emergency stop switch, the
machine stops.
●Push the nearest emergency stop switch (two
locations). Either switch stops the machine.
[How to reset]
When you are ready to restart operation, turn the
emergency stop switch clockwise and pull out after
checking and clearing any danger or abnormalities.
●The machine located on the right side seen from
the machine front also stops along with the one on
which the emergency stop switch is pushed. Other
machines do not stop. (See the picture above)
(If you continue to operate the machine in a dangerous
or abnormal state, an accident will occur)
Machine
does not stop
Machine
stops
Once the emergency
stop switch has been
pushed
Front side
Confirmation
DANGER
NPM-TT2 EJM1EE-SF-01N-05
1-1-3
Do not disable safety
switches
(Risk of injury)
Replenish-section
open/close switch
●It has a function of
safety switch
●Installed under the
cover
Safety switch
(In the magazine
door)
Single tray feeder
(option)
Safety switches
(Under rear safety cover)
Safety switches
(Under front safety cover)
●When safety switches on safety convers are
activated during operation , the machine stops.
Safety precautions 2
1-1
Single tray feeder 13-slot supply
unit
Single tray feeder coupling part
Safety switch
(Single tray feeder
coupling part)
DANGER
NPM-TT2 EJM1EE-SF-01N-05
ON
OFF
ON
OFF
OFF ON
Observe the following when placing any part
of your body into a moving part of the machine
(Risk of electric shock/Risk of injury if the machine is actuated)
Please handle according to your task.
●When repairing control units
→Cut off the power supply of the factory that
this machine is connected to.
●When performing periodic inspection or exchanging
control parts such as consumable parts, sensors or
head units
→Turn off the main power supply switch and lock out
the machine.
●When performing changeovers or daily
maintenance, installing nozzles to the nozzle changer,
placing a PCB on or removing it from the conveyor,
performing maintenance of the inside of the machine
→Turn off the servo switch and open the safety cover.
1-1-4
Servo switch
(Located in front and
rear)
Main power switch
(Located in front)
Be sure to observe the following
Confirmation