CP-842E-842ME System Reference-SYS-CP842-10E - 第124页

Machine System >> Panel ID Read Func tion (Option) 4-88 SYS-CP842-1.0E The communication port to be used for the pa nel ID reader connection can be specified at the [Barcode Management] screen. ID reading tests can…

Machine System >> Panel ID Read Function (Option)

SYS-CP842-1.0E 4-87

4.5.4 Settings for Panel ID (1D Code) Reading by

Dedicated Barcode Reader

Setting the Connection Port No. For Barcode Reader Com-

munication

Note: On machines equipped with barcode readers, this setting is specified at the factory, and does

not require setting by the user.

Select the [Maintenance] - [Configuration] commands to display the [Barcode Manage-

ment] setting screen.

Machine System >> Panel ID Read Function (Option)

4-88

SYS-CP842-1.0E

The communication port to be used for the panel ID reader connection can be specified

at the [Barcode Management] screen. ID reading tests can also be performed here.

1 A green indicator appears over the [Use Upper ID Reader] button when on (upper ID

reader “Used”).

2 Depressed when “Used” setting is specified.

3 Sets the Upper ID Reader’s connection port No. Press to display a ten-key pad, then

enter the port No. to which the Upper ID Reader is to be connected. Use care to avoid

entering a vacant port No. or a port No. in use by another device. This port No. setting

is a factory setting, and does not normally require changing.

4 “Port No.” display area.

5 On/off indicator for the [Use Lower ID Reader] button.

6 Depressed when “Used” setting is specified.

7 Sets the Lower ID Reader’s connection port No. Press to display a ten-key pad, then

enter the port No. to which the Lower ID Reader is to be connected. Use care to avoid

entering a vacant port No. or a port No. in use by another device. This port No. setting

a factory setting, and does not normally require changing.

8 “Port No.” display area.

C73OM0045

Machine System >> Panel ID Read Function (Option)

SYS-CP842-1.0E 4-89

Fujitrax-Profiler Settings

Perform the same setting procedures for code reading by the mark camera.

Barcode Reader Adjustment

The barcode reader position must be adjusted to accommodate a production panel

change, or changes in the panel ID barcode position. In such cases, adjust the reader

to a position where normal reading can occur.

Adjust the following as necessary:

• Position (Y-direction), Height (33 mm 5 mm)

• Barcode reader tilt

(A tilt of 10~40 degrees, 15~40 degrees is required. See the illustration below.)

• Barcode reader orientation (parallel or perpendicular to conveyance direction).

View from above in-conveyor

View of in-conveyor from left side of machine

Barcode reader

orientation adjustment

Position adjustment

Barcode reader

Trigger sensor

In-conveyor

Production panel

Barcodes

Barcode reader

Tilt adjustment

(15 ~ 40 deg.)

Tit adjustment

(10 ~ 40 deg.)

Height adjust

(33 mm ± 5 mm)