CP-842E-842ME System Reference-SYS-CP842-10E - 第31页
The Machine >> Machine Overview SYS-CP842-1.0E 3-9 3.1.4 Machine Controls The machine uses a combination of a touc h screen an d conventional push buttons. The major buttons on the operation box and touch s creen a…
The Machine >> Machine Overview
3-8
SYS-CP842-1.0E
11 Panel unclamping and unloading
When population of the current panel(s) is complete, the XY-table moves to the out-
carrier.
At this position, the XY-table is raised and the panel is transferred from the table to
the out-carrier (K).
The out-carrier subsequently moves to the out-conveyor and the panel is lowered onto
the out-conveyor via the out-lifter. The panel is unloaded (L).
Note: This explanation describes single panel production. The double panel production option is the
same except for the use of stoppers to position the second panel at the in- and out-conveyor.
K
Out-carrier
L
Out-conveyor
C7SM1003a
The Machine >> Machine Overview
SYS-CP842-1.0E 3-9
3.1.4 Machine Controls
The machine uses a combination of a touch screen and conventional push buttons.
The major buttons on the operation box and touch screen are detailed below.
POWER ON lamp
This indicator is lit when the main breaker is set to the ON position.
SYSTEM ON button
This button turns on the power supply to the machine and boots up the control soft-
ware.
POWER
ON
READY
ON
Side 1
START
EMERGENCY
STOP
SYSTEM
ON
ENABLE
LOCK
CYCLE
STOP
F
θ
θ
C73OM007
The Machine >> Machine Overview
3-10
SYS-CP842-1.0E
START button
This button is pushed to commence operation. This button can only be pushed when
the machine is in START ready status (i.e., when the button is flashing).
CYCLE STOP button
This button can be used during operation to stop the machine at the end of the current
movement. Unlike the EMERGENCY STOP button, pressing CYCLE STOP does not
cut the 200V power.
READY ON button
This button cancels an error status and resupplies the 200V power to the servo sys-
tem.
EMERGENCY STOP button
Pressing an EMERGENCY STOP button cuts the 200V power to the machine and
stops operation immediately. This button locks in position when pressed, and must be
turned clockwise to release it.
Users should familiarize themselves with the locations of the EMERGENCY STOP
buttons prior to operating the machine. In addition to the button on the front of the
machine (shown in the figure above), further EMERGENCY STOP buttons are posi-
tioned at the rear of the machine, and on the optional MTU safety fence.
Refer to the illustration in Chapter 5 of the Safety Guidelines to confirm the positions
of all the EMERGENCY STOP buttons.
Side 1/2 ENABLE/LOCK switch
Toggle this switch to enable operation at the desired side; front (Side 1) or rear (Side
2), of the machine. Operation at a given side of the machine cannot be enabled if the
switch at the other side of the machine is set to LOCK.
Power Off button (touch screen command that displays when the EMERGENCY
STOP button is pushed)
The [Power Off] button is used to turn off the main power to the machine.
This button can only be pressed after the EMERGENCY STOP button has been
pushed.