X-Series-Maintenance-Manual(1) - 第87页
Major Maintenance Performing Maintenance Tasks Maintenance Tasks for C&P20A Head Maintenance Manual SIPLACE X Series 87 ► Remove the black rubber ho se bet ween the Z axis and the dr iver. Checkin g/Replaci ng the Fi…
Major Maintenance
Maintenance Tasks for C&P20A Head Performing Maintenance Tasks
86 Maintenance Manual SIPLACE X Series
► Move the segment on the Z axis rotor out as far as the end stop. Make sure that the driver bearing
is in the center of the jaws.
► Apply another 2 µl of lubricant to each guideway and move the segment again approx. 5 times.
A total of 4 µl must be applied to each guideway.
► Move the Z axis upwards again.
► Make sure that the driver bearing is in the center of the jaws.
► Turn the star on to the next segment.
► Repeat this maintenance task for all segments.
► Fit the removed nozzle back into place.
Oiling th e Z Axis Lin ear Guidance
5.5.5.3 Oiling the Z Axis Linear Guidance
► For this maintenance task, use the blue combitip with Thermoplex ALN 1001/00.
► Set the multipette to 4 µl.
► Move the segment on the Z axis rotor manually out as
far as the end stop and back in approx. 5 times.
► Hold the Z axis by the rotor, in its uppermost position.
► Apply 4 µl of lubricant to the outer guideway of the
rail.
Make sure that the application nozzle is positioned
near to the guidance trolley.
Major Maintenance
Performing Maintenance Tasks Maintenance Tasks for C&P20A Head
Maintenance Manual SIPLACE X Series 87
► Remove the black rubber hose between the Z axis and the driver.
Checkin g/Replaci ng the Filter Disk s
5.5.5.4 Checking/Replacing the Filter Disks
Check
► Move the Z axis into its bottom position.
► Apply 4 µl of lubricant to the inner and outer guideway
of the rail and move the Z axis approx. 5 times
manually in and out.
► Apply another 4 µl of lubricant to the inner and outer
guideway of the rail and move the Z axis again
approx. 5 times manually in and out.
CAUTION
Remove rubber hose
If the rubber hose is not removed, the head will crash!
NOTICE
Check correct function
Check that the filter disks and vacuum distributors are working correctly by checking the
vacuum values in the software.
► Check the filter disks for contamination or damage.
► Replace any damaged filter disks.
Major Maintenance
Maintenance Tasks for C&P20A Head Performing Maintenance Tasks
88 Maintenance Manual SIPLACE X Series
Replacing the filter disks
NOTICE
Replacing the filter disks
► Read the "User manual, insertion and extraction tool for filter disks, C&PA 20" (item no.:
00195378-xx). before replacing the filter disks.
► Use the "insertion and extraction tool for filter disks"
to remove the filter disks from the 20 segments of the
placement head.
► Use the insertion and extraction tool to place a new
filter disk on each segment. The filter disks must
engage audibly.
► Check whether the filter disk is fitted correctly. The
filter disk must be fitted straight on the DP drive.