4OM-1054-002 - 第34页

Fig. 4A22 0303-005 1-21 AGS01ETRP 1.3 Maintenance Spots Cam Follower Opening of Head Cap Miniature Stroke Bearing 1M2 Every Month Inspection/Lubrication (DAPHNE EPONEX GREASE No. 1) Move the cam follower to the lowest po…

(9) Head Section

1.3 Maintenance Spots

0307-006 1-20 AGS01ETRP

Fig. 4A20

Vacuum Nozzle 3M7

Every 3 Months Inspection

Check the condition of the vacuum nozzle. When the

nozzle end is worn out, replace it with a new one.

Note: Refer to "1.4 Maintenance Method" for the

detailed information on how to detach or attach

the vacuum nozzle.

Diffusion Plate 1M1

Every Month Cleaning

When dirt and dust have accumulated on the lower

surface of the diffusion plate, wipe them off with the

lens cleaning cloth (the standard accessory part).

Note: Never use neither solvent nor ethanol.

Otherwise, the diffusion plate may crack.

Vacuum Nozzle 1W7

Every Week Cleaning

• Clean the tapered area of the nozzle with a lens

cleaning cloth (standard accessory part).

• Detach the nozzle and blow air to remove dirt and

dust.

Note: When the nozzle is heavily stained, detach and

clean it with an ultrasonic cleaner or a rag

soaked in alcohol.

If alcohol is used with the nozzle being attached,

it will adhere to the diffusion plate, causing the

plate to crack.

Refer to "1.4 Maintenance Method" for details.

Diffusion Plate 1W6-1

Every Week Inspection/Cleaning

Check that no grease adheres to the upper surface of

the diffusion plate.

If necessary, wipe off the grease with a clean and dry

rag.

Note: Never use neither solvent nor ethanol.

Otherwise, the diffusion plate may crack.

Fig. 4A22

0303-005 1-21

AGS01ETRP

1.3 Maintenance Spots

Cam Follower

Opening of Head Cap

Miniature Stroke Bearing 1M2

Every Month Inspection/Lubrication (DAPHNE EPONEX GREASE No. 1)

Move the cam follower to the lowest position.

Push up the vacuum nozzle and release your finger. When the vacuum nozzle does not

move down smoothly, cleaning and lubrication are required.

Note: Refer to "1.4.5 Disassembly, Cleaning, and Lubrication of Miniature Stroke

Bearing".

Miniature Stroke Bearing 6M11

Every 6 Months Cleaning

• Refer to "1.4.5 Disassembly, Cleaning, and Lubrication of Miniature Stroke Bearing"

and wash the MSB shaft and outer cylinder with kerosene for 5 to 10 minutes, using

the ultrasonic cleaner.

• When the upper and lower seals are scratched or deformed or foreign substances

have accumulated on them, replace them with new ones (630 048 0849).

Fig. 4A21

1.3 Maintenance Spots

0211-004 1-22 AGS01ETRP

(10) Linear Measure Detection Section

Fig. 4A23

Fig. 4A24