00192231-09_VD_SSW 407.05_de en - 第59页
Software Version Description, Station Software Version 407.05 07/2008 Edition 8 Enclosures None 59 of 104
Software Version Description, Station Software Version 407.05 07/2008 Edition
7.1.10 Miscellaneous
• Conveyor mode 2 (PCBs longer than 508 mm) is not supported.
• Fine calibration cannot be carried out when ceramic substrate centering is installed. There is a risk of
damaging the conveyor when inserting the light table.
• Feeder position recognition is only possible for track 115 to a limited extent, because the relevant gantry
cannot move to the feeder fiducial for track 115.
• The reference designator is transferred to GEM with a length of only 21 characters.
58 of 104
Software Version Description, Station Software Version 407.05 07/2008 Edition
8 Enclosures
None
59 of 104
Software Version Description, Station Software Version 407.05 07/2008 Edition
9 Installation Instructions
9.1 Prerequisites
If you are upgrading to version 406 from a software version earlier than 407, make sure that the connectors
(if fitted) of the V24 link between machine controller and station computer have been disconnected on both
sides. This applies both to the installation and the operation.
9.1.1 Station Computer
Prerequisite for the installation of the station computer version 407.05 is the successful installation of the
Windows NT 4.0 operating system (including Service Pack 6 and the Microsoft Security Patch for Windows
NT 4.0) or the Windows XP operating system (including Service Pack 1). Prior to installing the software,
back up all machine data (*.ma) and the files for the option settings (*.opt) contained in the directory
C:\SRDaten\SrcMa.
Microsoft security patch for Windows NT 4.0
This patch from Microsoft must be installed due to sporadic network errors. Since the patch is language-
specific and only German and English versions can be offered on the CD, other language variants –
where necessary – must be downloaded directly from Microsoft.
The software is found on the CD under:
Siplace\Nt_srp\Deutsch\Q299444i.exe or Siplace\Nt_srp\English\ Q299444i.exe
The software is provided here:
http://www.microsoft.com/ntserver/nts/downloads/critical/q299444/default.asp?FinishURL=%2Fdownloa
ds%2Frelease%2Easp%3FReleaseID%3D31243%26area%3Dsearch%26ordinal%3D14%26redirect%3
Dno
9.1.2 Machine Controller
For the installation of the machine controller 407 it is imperative that a bootable RMOS installation (version
3.20) has been carried out on the C-partition of the hard disk of the MC module.
Required partitioning of the hard disk: C: partition 50 MB, active boot partition
D: partition 150 MB, SIPLACE software
See section
9.2.
60 of 104