00191099-01 - 第43页
Component B ar-Code Sc anner (Optional) Retrofitting Instructions SIPLACE 80 / S-23 (HM) / HS-50 Issue 06/00 2.7 Component Bar-Code S canner on S-20/F4/F4-6/F5 (HM) and S- 23 (HM) 43 Fig. 2.7.2 PC Carrier 4 for F4 / F4-6…
Retrofitting Instructions SIPLACE 80 / S-23 (HM) / HS-50 Component Bar-Code Scanner (Optional)
2.7 Component Bar-Code Scanner on S-20/F4/F4-6/F5 (HM) and S-23 (HM) Issue 06/00
42
Fig. 2.7.1 Attaching the Component Scanner to PC Carriers 2 and 3
Key:
1. Hand-held scanner
2. Short cable
3. Long cable
4. Holes to fasten the bar-code bracket
5. Bar-code bracket
6. Signal filter and Velcro fastener
7. Strain relief
8. Keyboard cable
9. Splitting of keyboard cable and trackball cable
10. Trackball cable
11. Cable to the Machine Controller
The signal filter must be fastened as far DOWN as possible: see illustration.
Component Bar-Code Scanner (Optional) Retrofitting Instructions SIPLACE 80 / S-23 (HM) / HS-50
Issue 06/00 2.7 Component Bar-Code Scanner on S-20/F4/F4-6/F5 (HM) and S-23 (HM)
43
Fig. 2.7.2 PC Carrier 4 for F4 / F4-6 / F5 (HM) / S-20 / S-23 (HM)
NOTE:
If the PC carrier 4 shown above has already been installed on the machine, fasten the bar-code
bracket including the remaining assembly and cabling of the hand-held scanner as described for
PC carriers 2 and 3 (see Fig. 2.7.1).
+DUGZDUH,QVWDOODWLRQIRU3&&DUULHU
Å Turn the machine OFF and isolate the machine from the mains (for details, see: DANGER text
in Section 2.2).
Å Leave the safety hoods closed.
Å Unplug the plug-and-socket connections on the back of the station monitor.
Å Lift the station monitor off the carrier.
Å Attach the bar-code bracket to carrier 1 from below (position: see Fig. 2.7.3) with the 2 socket
hex head cap screws M4 and the 4 washers provided (place 2 washers A4.2, DIN 125, under-
neath each screw).
Å Glue one part of the Velcro fastener (from the retrofit kit) to the side of PC carrier 1 (position:
see Fig. 2.7.3).
Retrofitting Instructions SIPLACE 80 / S-23 (HM) / HS-50 Component Bar-Code Scanner (Optional)
2.7 Component Bar-Code Scanner on S-20/F4/F4-6/F5 (HM) and S-23 (HM) Issue 06/00
44
Fig. 2.7.3 Mounting the Component Bar-Code Scanner on the PC Carrier 1
Key:
1. Hand-held scanner with cable
2. Short cable
3. Long cable
4. Drilled holes to attach the bracket for the hand-held scanner
5. Bracket for hand-held scanner
6. Signal filter
7. Cable strain relief device
8. Keyboard cable
CAUTION
During the following drilling do not let any chips drop into the machine and do not damage any
cables. The safety hoods must be left closed and covered with a cloth so that no chips can pass
through the gaskets.