OM-1273-004_w - 第121页
3-12 AJK-ML T-ID 4.1.2 Unit Offset When the "Unit Ofst" subtab is pressed in the "Device Offset" tab sheet and the "T ray" subtab is further pressed, the following subtab sheet appears. Fig.…
3-11
AJK-MLT-ID
4. System Setting
4.1 Offset Data
4.1.1 Feeder (B) Offset
Open the "System" window (main menu).
When the "Fdr-B" subtab is pressed in the "Device Offset" tab sheet and the
"Tray #3" subtab is further pressed, the following tab sheet appears.
[1] [2]
Fig. C8 "Tray #3" Subtab Sheet (Multi-Layer Tray Feeder #3 Used)
Note
The displayed subtab sheet will look different, depending on which option
is selected.
[1] Tray Step
Shown are the tray step Nos.
[2] Block #1 through #9
X [mm] (Horizontal) and Y [mm] (Vertical)
The set parameters are used to correct the variation in the X and Y
directions of each block of steps.
The values based on the placement reference coordinates system must
be entered in these text boxes.
Enter the positional deviations from the pickup position for each
individual pallets, including the traverse drawout position (multi-layer
tray offset), such that components can be picked up at their centers.
L [mm]
(Height)
The set parameters are used to correct the variations in the pickup
height of the individual blocks of each step.
These parameters are reected on the descending stroke of the head
required to pick up a component.
4. System Setting
0804-003
3-12
AJK-MLT-ID
4.1.2 Unit Offset
When the "Unit Ofst" subtab is pressed in the "Device Offset" tab sheet and
the "Tray" subtab is further pressed, the following subtab sheet appears.
Fig. C9 "Tray" Subtab Sheet (Multi-Layer Tray Feeder #3 Used)
Note
The displayed subtab sheet will look different, depending on which option
is selected.
4.1 Offset Data
0804-003
3-13
AJK-MLT-ID
(1) Traverse
These offset data is used to adjust the position where a pallet is drawn
out by the traverse shafts.
Traverse [mm]
When a pallet is drawn out, the traverse shafts move as far as the
specied distance where the parameter set in this text box is added.
X
[mm] (Horizontal)
The set parameter is added to the beam travel when components are
picked up.
Y [mm] (Vertical)
The set parameter is added to the beam travel when components are
picked up.
(2) Traverse chute level
L [mm] (Height)
This offset data is used to adjust the level (height) of the pallet drawing
chute.
When
a level lower than the design height is set, a plus value must be
entered in the text box.
(3) Traverse chuck position
Traverse axis [mm]
This offset data is used to adjust the chuck position.
4.1 Offset Data
0706-002