OM-1273-004_w - 第140页
4-1 1 AJK-ML T-ID 0706-002 3.3.2 Elevator Shaft Before the maintenance work, manually move the elevator to the position for easier lubrication work and turn off the power . The maintenance cover must be detached to apply…
4-10
AJK-MLT-ID
0706-002
3.3 Inspection, Cleaning, and Lubrication Spots
3.3 Inspection, Cleaning, and Lubrication Spots
The following describes about the maintenance tasks required for each
individual units.
Reference
Refer to "2. Maintenance Check List" for the maintenance items classied
based on frequency.
3.3.1 Pallet
.OTE
When the pallet is warped, the component pickup rate may deteriorate.
Pallet
Every Month Inspection and Cleaning
Required Time: 1 minute
When the pallet is dirty, clean both top and
bottom surfaces with a rag.
Top Surface
Every 3 Months Inspection
Required Time: 1 minute
Check for the warpage of the pallet with a
scale. (Up to Max. 0.5 mm)
Rails
Every 3 Months Inspection
Required Time: 2 minutes
Check the wear of the bottom surfaces of
the pallet rails with a scale.
(Up to Max. 0.5 mm)
Fig. D4 Pallet
4-11
AJK-MLT-ID
0706-002
3.3.2 Elevator Shaft
Before the maintenance work, manually move the elevator to the position for
easier lubrication work and turn off the power.
The maintenance cover must be detached to apply grease to the elevator
shaft.
Reference
Refer to "4.1 Detachment and Attachment of Maintenance Cover" for how
to detach the cover.
Ball Screw
Every 3 Months Lubrication
(DAPHNE EPONEX GREASE No. 1)
Required Time: 10 minutes
Wipe off old grease with an oiled rag and
apply new one with a brush.
Take ample care not to leave any
waste threads after cleaning.
Notice
Fig. D5
3.3 Inspection, Cleaning, and Lubrication Spots
4-12
AJK-MLT-ID
3.3 Inspection, Cleaning, and Lubrication Spots
0706-002
Linear Guide
Every 3 Months Lubrication
(DAPHNE EPONEX GREASE No. 1)
Required Time: 5 minutes
Wipe off old grease with an oiled rag and
apply new one with a brush or supply
grease from eight grease nipples with a
grease gun.
Take ample care not to leave any
waste threads after cleaning.
Notice
Belt
Every 3 Months Inspection
Required Time: 1 minute
Visually inspect the wear of the belt.
Fig. D6