OM-1273-004_w - 第27页
Safety Precautions Safe-16 AJK-ML T-ID 5. Precautionary Items for Correct Operations Requirements for Installation Besuretofulllthefollowingrequirementsforsafetypurposes. • Overvoltage Category : Category I I I…
Safety Precautions
Safe-15
AJK-MLT-ID
No. Alert Labels and Description
(4)
WARNING
Moving Mechanisms!
Description
Pay attention to the moving mechanisms. Otherwise, you may be trapped by the
moving mechanisms and a serious accident will result.
(5)
WARNING
Keep the door closed during
operation.
Otherwise, part of your body may be trapped
in the moving mechanisms, causing an injury.
Do not keep the door open during operation.
Description
Do not open the door while the multi-layer tray feeder is running. Otherwise, the
magazine will pop out, leading to a serious accident.
(6)
Prevent fingers
being pinched.
WARNING
Description
Pay special caution not to get your ngers trapped. Otherwise, your ngers will get
injured and a serious accident will result.
0706-002
Safety Precautions
Safe-16
AJK-MLT-ID
5. Precautionary Items for Correct Operations
Requirements for Installation
Besuretofulllthefollowingrequirementsforsafetypurposes.
•
Overvoltage Category : Category
I
II
•
Pollution Degree : 3
Overvoltage Categories refer to the level of Impulse Withstand
Voltage protection
provided at the specied Pollution Degree.
Category I
I
I
: Primary circuits of a device to which power is directly
supplied from the power distribution panel, and circuits from
the distribution panel to outlets.
Note
The term was changed from "Installation Category" to "Overvoltage
Category".
"Pollution Degree" is a degree of pollution severity.
Pollution Degree 3: Conductive pollution or dry nonconductive pollution
that becomes conductive due to condensation occurs.
To be found in industrial environment or construction
sites (harsh environments).
0706-002
Safety Precautions
Safe-17
AJK-MLT-ID
Precautionary Measures before Installation
If the machine is installed in unsatisfactory environmental conditions, it may malfunction
due to damage or breakdown.
To avoid this, make preparations to install the machine as follows.
When the machine is scheduled to be transferred to another place, please contact the
marketing department or sales agency of Hitachi High-Technologies beforehand.
Select a place solid enough to support the mass of the machine.
Note
It is recommended that the machine should be installed on the rst oor.
When the machine has to be installed on a oor other than the rst one,
please contact the marketing department or sales agency of Hitachi High-
Technologies for details.
Avoid any place that vibrates severely.
The ambient temperatures must be 20±10°C and humidity 30 to 8
0%. Any dew
condensation must be avoided.
When the machine is transferred to another place and the ambient temperature rises more
than the surface of the machine, dew may condense under the condition described below.
Note that dew condensation may cause the machine to break down.
Condition of Dew Condensation
Dew may condense when the difference (based on "Humidity (%)") between the ambient
temperature of the destination (the place where the machine was transferred) and the
surface temperature of the machine reaches the values or more in the table below.
Humidity (%) of Destination
Differences between Ambient Temperature of
Destination and Surface Temperature of
Machine
80 3 °C or more
70 6 °C or more
60 8 °C or more
5
0 10 °C or more
40 14 °C or more
30 1
8 °C or more
0706-002