OM-1273-004_w - 第47页

1-10 AJK-ML T-ID 0706-002 3. Name of Each Section and Handling 3. Name of Each Section and Handling This feeder is constructed of an elevator , magazines, a traverse, pallets, and tray magnets. W A R N I N G There are st…

1-9

AJK-MLT-ID

0706-002

2.2 Outline of Actions

(1) A pallet is pulled out from the magazine stored in the elevator section

onto the traverse according to the pattern program data.

(2) The placement heads of the main machine pick up components from the

pallet that was pulled out onto the traverse.

(3) The images of the picked components (the components picked up by

the placement heads) are captured and recognized by the component

recognition cameras to detect the deviation in the pickup position.

The detected deviation is corrected and the components are placed

accurately on the specied positions.

When a pickup error or a recognition error is detected during the

component recognition, the machine performs the dischar

ge operation

of the rejected component.

(4) The pallet on the traverse is stored in the magazine of the elevator and

the subsequent pallet is pulled out onto the traverse according to the

pattern program data.

When the subsequently placed component originates from the same

pallet, the pallet stays on the traverse.

(5)

Steps (1) through (4) are repeated.

When the tray on the pallet (specied in the pattern program data)

becomes empty of components, the LED of the step No. button starts

ickering and the error message "Component Shortage Error" appears

on the operation monitor. In this case, reload the tray with components.

1-10

AJK-MLT-ID

0706-002

3. Name of Each Section and Handling

This feeder is constructed of an elevator, magazines, a traverse, pallets, and

tray magnets.

WARNING

There are strong motorized and high-voltage areas inside the

machine. Special caution should be paid not to touch them.

Doing otherwise will cause personal injury (serious accident).

·

Onlyqualied

maintenancepersonnelshoulddetach

the covers.

·

The machine should be operated with the covers

being attached.

·

If a cover is detached, be sure to reattach it.

·

Be sure to close the magazine door before operating

the machine.

·

Do not disengage the interlock of the magazine door.

Elevator

Elevator Power LED

Magazine #2 Supply Position

Upper Magazine

Change Position

Magazine Change Position

Magazine #1 Supply Position

Lower Magazine

Change Position

Traverse

Magazine #2 Door

Exchange Position Door

Magazine #1 Door

Magazine #2 Ready Switch

Exchange Position

Ready Switch

Magazine #1 Ready Switch

Fig. A1 Multi-Layer Tray Feeder (Front Side of Machine)

1-11

AJK-MLT-ID

Rack Shutter

MG-G110MG-G115

Magazine Door Magazine Door

Fig. A2 Magazine

Pallet (MP-G100)

Tray Magnet

(MF-G100)

Fig. A3 Pallet and Tray Magnet

WARNING

Do not bring the tray magnet close to the area where a

pacemaker is implanted. Otherwise, the pacemaker may be

affected by the magnetism and a serious accident will result.

0706-002

3. Name of Each Section and Handling